Electrogeneration of Hydrogen Peroxide in Acid Medium using Pyrolyzed Cobalt-based Catalysts: Influence of the Cobalt Content on the Electrode Performance

• DOI: 10.1007/s10800-005-7174-3
• Publication Date: 2006-06-08T09:50:27Z
• Authors: N. Guillet; L. Roué; S. Marcotte; D. Villers; J. P. Dodelet; N. Chhim; S. Tré Vin
• Keywords: Gas diffusion electrode; Cobalt oxide; Rotating ring-disk electrode; Reversible hydrogen electrode; Saturated calomel electrode

Cobalt tetramethoxyphenyl porphyrin (CoTMPP) adsorbed on a high area carbon support (Vulcan XC72-R) and heat-treated at 900 °C under inert atmosphere was studied as electrocatalyst for the reduction of O2 to H2O2 in acid medium. Experiments performed on rotating ring-disc electrode (RRDE) and gas diffusion electrode (GDE) show that the catalyst performance depends on the cobalt loading, going through a maximum at 0.2 wt. % Co. For higher cobalt loadings, a growing part of oxygen is reduced into water, decreasing therefore the selectivity of the catalyst. These results are interpreted in terms of a further reduction of H2O2 on Co-based catalytic sites before leaving the catalytic layer. For a GDE polarized at −150 mV vs. saturated calomel electrode (SCE) and loaded with 0.9 μg cm−2 of 0.2 wt. % Co-based catalyst, a H2O2 production rate of 300 μmol h−1 cm−2 was obtained which is five times higher than the H2O2 production rate measured with Vulcan. In these conditions, the selectivity of the Co-based catalyst for H2O2 production is 92%. The good agreement observed between RRDE and GDE results confirms the relevance of using RRDE experiment for screening these non-precious metal catalysts for further GDE applications.