Femtosecond laser micromachining of a single-crystal superalloy

• DOI: 10.1016/j.scriptamat.2005.05.006
• Publication Date: 2005-06-10T12:37:05Z
• Authors: Q. Feng; Y.N. Picard; H. Liu; S.M. Yalisove; G. Mourou; T.M. Pollock
• Keywords: Laser Ablation; Laser beam machining

Investigations on femtosecond laser micromachining of single crystal superalloys with and without plasma-sprayed thermal barrier coatings were conducted under laser fluences ranging from 0.1 J/cm 2 up to 160 J/cm 2 . Micromachining was carried out in air using a titanium:sapphire laser system (O = 780 nm) operating at a repetition rate of 1 kHz and delivering individual pulses of ~150 fs duration. The ablation threshold of the single crystal superalloy was determined as 203 ± 20 mJ/cm 2 . Laser-induced damage was examined by means of scanning electron microscopy and transmission electron microscopy. These studies indicate a complete absence of any melting, recast layers, heat-affected zones or microcracks in the vicinity of the machining area. The only form of damage observed in the single crystal superalloy machined near or above the ablation threshold was a laser-induced plastically deformed layer with a maximum extent of ~5 Pm. Machining through ceramic thermal barrier coatings on a superalloy produced no delamination along the superalloy/coating interfaces or cracks within the TBC or bond coat. The residual roughness of the machined surface was in the sub-micron range. The present study suggests that femtosecond laser micromachining is a very promising technique for production of finescale features in multi-layer material systems for aerospace and power generation components.