A5038246075- Additive Manufacturing Materials and Processes
- Additive Manufacturing and 3D Printing Technologies
- High Entropy Alloys Studies
- Advanced materials and composites
- Surface Treatment and Coatings
- Welding Techniques and Residual Stresses
- Aluminum Alloys Composites Properties
- Metal and Thin Film Mechanics
- Engineering Technology and Methodologies
- Manufacturing Process and Optimization
- Metal Alloys Wear and Properties
- Injection Molding Process and Properties
- Advanced machining processes and optimization
- Engine and Fuel Emissions
- Intermetallics and Advanced Alloy Properties
- Renewable energy and sustainable power systems
- Cellular and Composite Structures
- Waste Management and Environmental Impact
- Thermal and Kinetic Analysis
- Material Properties and Applications
- Environmental and Industrial Safety
- Mechanical Engineering Research and Applications
- Chemical Safety and Risk Management
- Structural Analysis of Composite Materials
- Energetic Materials and Combustion
West Pomeranian University of Technology
2014-2023
Wrocław University of Science and Technology
2013-2017
Zachodniopomorskie Centrum Onkologii
2012-2016
University of California, Los Angeles
2016
This study involves the fabrication of triply periodic minimal surface sheet lattices possessing two different topologies—Neovius and Schoen's IWP. The structural characteristics these materials, which were fabricated by laser powder bed fusion using CoCrMo alloy powder, investigated. tensile properties deformation behavior materials evaluated increasing unit cell size (1, 2.5, 5 mm) for each topology. results tests showed that yield strengths Young's moduli both topologies decreased, their...
CoCrMo sheet triply periodic minimal surface (sheet-TPMS) lattices with two different topologies (Neovius, IWP) were fabricated by laser power bed fusion (LPBF). Compressive behavior and energy absorption characteristic for each topology direction investigated. The unique pore channel structures of the Neovius IWP well formed. microstructural observation revealed that fine cellular substructures existed inside sheets, most their constituent phases confirmed to be FCC phase. results...
The wear properties of Ti-6Al-4V alloy have drawn great attention in both aerospace and biomedical fields. present study examines the as prepared by selective laser melting (SLM), electron beam (EBM) conventional forging processes. SLM EBM samples show better resistance than forged sample, which correlates to their higher hardness values weak delamination tendencies. sample shows a lower rate because formation multiple horizontal cracks results heavier delamination. suggest that additive...
The fracture toughness of AISI H13 tool steel, additively manufactured by laser powder bed fusion (L‐PBF) technique, is studied. influence the building direction on investigated small notched bending samples heat treated according to two different thermal cycles, namely, quenching and tempering (QT) only (T). notch electro‐discharge machined parallel (P || ), perpendicular ⊥ longitudinal (L) direction. Both treatments, even if a extent, delete as‐built (AB) microstructure, producing...