A5101530735- Advancements in Battery Materials
- Real-time simulation and control systems
- Supercapacitor Materials and Fabrication
- Advanced Battery Materials and Technologies
- Drilling and Well Engineering
- Crystal structures of chemical compounds
- Hydraulic and Pneumatic Systems
- Hydrocarbon exploration and reservoir analysis
- Microbial Fuel Cells and Bioremediation
- Vehicle Dynamics and Control Systems
- Carbon dioxide utilization in catalysis
- Electrochemical sensors and biosensors
- Fault Detection and Control Systems
- Analytical Chemistry and Sensors
- Enhanced Oil Recovery Techniques
- Electrical Fault Detection and Protection
- Graphene research and applications
- Petroleum Processing and Analysis
- Fire Detection and Safety Systems
- Advanced Battery Technologies Research
- Vibration Control and Rheological Fluids
- Electric Motor Design and Analysis
- ZnO doping and properties
- Gas Sensing Nanomaterials and Sensors
- Fire dynamics and safety research
State Key Laboratory of Automotive Simulation and Control
2016-2024
Jilin University
2002-2024
Harbin University
2020-2023
Grinm Advanced Materials (China)
2022-2023
Fraunhofer Institute for Wind Energy Systems
2021-2022
China Automotive Battery Research Institute
2020
Binzhou University
2018-2020
China University of Petroleum, East China
2015-2018
Nanjing Tech University
2015-2017
BOE Technology Group (China)
2016
Abstract BACKGROUND Microbial electrosynthesis (MES) is a biocathode‐driven process, producing high‐value chemicals, from CO 2 . However, the low efficiency of biocathode hinders MES process significantly. RESULTS A novel 3D graphene–nickel foam (G‐NF) cathode has been fabricated, by hydrothermal approach for improvement microbially‐catalyzed reduction at cathode. An increase 1.8 times in volumetric acetate production rate was obtained, compared with untreated nickel foam. In G‐NF, 3.11 mmol...
The one-pot synthesis of glycidol from glycerol and dimethyl carbonate (DMC) was developed by using a solid base catalyst. A series catalysts have been investigated in this reaction. It found that NaAlO2, cheap easily available raw material, highly efficient heterogeneous catalyst for the glycidol, it can be recovered reused. Under reaction conditions DMC–glycerol molar ratio 2, catalyst–glycerol weight 3%, time 90 min, temperature 80–92 °C, conversion selectivity to reached 94.7% 80.7%,...
The confinement of Sn nanoparticles inside few-walled carbon nanotubes and its effect on lithium ion storage property have been investigated in detail. It was found that the charge transfer electronic interaction facilitated to remain a more reduced state link strongly with interior surface by Sn–C bonds, leading high reversible capacity 732 mAh g–1 retention 639.7 after 170 cycles at 50 mA g–1. We also volume restriction CNTs protected bonds against breakage during insertion/extraction,...
To prevent the deposition of natural gas hydrate in deepwater well, formation area wellbore must be predicted. Herein, by comparing four prediction methods temperature pipe with field data and five experiment data, a method based on OLGA & PVTsim for predicting was proposed. Meanwhile, The under conditions steady production, throttling shut-in predicted using this well South China Sea. results indicate that decreases increase inhibitor concentrations thickness insulation materials increases...
Hyperspectral object-detection algorithms based on deep learning have been receiving increasing attention due to their ability operate without relying prior spectral information about the target and strong real-time inference performance. However, current methods are unable efficiently extract both spatial from hyperspectral image data simultaneously. In this study, an innovative algorithm is proposed that improves detection accuracy compared benchmark state-of-the-art algorithms....
For an energy transition towards renewable sources, the importance of traceable efficiency determination increases. There are standards for a rotating electrical machines as well power curve wind turbines in field. To speed up and ameliorate design process turbine, however, standardised method nacelle drive trains on test benches is required. In this paper, need recommendations such given.
The FeSe 2 nanorod@porous graphene film prepared by vacuum filtration, annealing, and subsequent selenylation is developed as an anode for lithium ion batteries. These nanorods are formed via confined oriented growth of nanoparticles.
With the increasing number and functional complex of automotive electronic equipment, more risks from systematic failures random hardware faults may occur. In light fact that a failure an programmable system lead to injuries even loss life it is extremely important perform hazard analysis during process design development these systems minimize risk occurrence such disastrous events. this paper, comprehensive method based on model proposed. This overcomes narrower scope individual techniques...
In this paper an arc fault detection method is proposed based on characteristics of the current electric arc. A localized signal processing developed using wavelet analysis to decompose differential into a series components, each which time-domain that covers specific frequency band. Thus, more distinctive features represent faults and other transient phenomena are extracted. As result, by quantifying extracted features, distinguished from similar transients differences in quantified...
Increasing functionality and complexity of automotive embedded system have led to more risks from systematic faults random hardware faults. This makes it necessary perform the functional safety process throughout lifecycle these systems. In addition, appearance new standard ISO 26262 also make consideration as part design implementation for systems is growing in importance. paper presents a comprehensive analysis approach based on model. The modeling outlined applied Dual Clutch Transmission...
Abstract The impact of system test benches on the development and validation wind energy converters is significantly increasing, that due to higher availability as well provided powerful actuator emulation systems. However, question remains be answered about how consistent measurements in laboratory are. Especially case where no field are available for prototypes. challenge this regard unknown accuracy simulations lack an experimentally calibrated torque measurement hardware-in-the-loop...
Based on the theory of jet drilling technology and displacement optimization, a set experimental equipment about is devised. The laws conductor pipe down-speed influenced by pump were studied laboratory experiments. According to results analysis, following conclusions can be drawn. increases with increasing displacement, also speed boosted. But unstableness borehole wall augmented as well. And this will result in waiting time for formation. In process jetting, soil returning certain bearing...
Sensor fault diagnosis is one of the important parts a vehicle control system. Normally we sort sensor faults as incipient-faults and abrupt-faults [5]. In this paper, focus on Hybrid electric vehicles (HEV) A novel method for diagnosing proposed based wavelet packet neural network (WPNN). The simulating test conducted in Matlab/Simulink MotoTron rapid prototyping platform. results after show that approach feasible effective detecting abrupt-faults.
Fe 3 C modified by the incorporation of carbon materials offers excellent electrical conductivity and interfacial lithium storage, making it attractive as an anode material in lithium-ion batteries.