A5068129982- Microstructure and Mechanical Properties of Steels
- Microstructure and mechanical properties
- Metallurgy and Material Forming
- Metal Alloys Wear and Properties
- High Temperature Alloys and Creep
- Hydrogen embrittlement and corrosion behaviors in metals
- Aluminum Alloys Composites Properties
- Aluminum Alloy Microstructure Properties
- Advanced materials and composites
- Metal and Thin Film Mechanics
- Magnesium Alloys: Properties and Applications
- Magnetic Properties and Applications
- Metal Forming Simulation Techniques
- Material Properties and Failure Mechanisms
- Additive Manufacturing Materials and Processes
- Welding Techniques and Residual Stresses
- High Entropy Alloys Studies
- Surface Treatment and Residual Stress
- Material Properties and Applications
- Fatigue and fracture mechanics
- Advanced ceramic materials synthesis
- Advanced Welding Techniques Analysis
- Fusion materials and technologies
- Intermetallics and Advanced Alloy Properties
- Advanced Materials Characterization Techniques
Belgorod National Research University
2016-2025
International Centre for Materials Physics
2025
Liaoning Academy of Materials
2025
Central Research Institute of Structural Materials Prometey
2019-2024
Kurchatov Institute
2019-2024
St. Petersburg State Technological Institute
2023
Institute of Problems of Mechanical Engineering
2019-2021
Federal Scientific Center for Agroecology, Integrated Land Reclamation and Protective Afforestation
2020-2021
Schlumberger (British Virgin Islands)
2018
Russian University of Transport
2016
The evolution of the new microstructures produced by two types dynamic recrystallization is reviewed, including those brought about severe plastic deformation (SPD). microstructural changes taking place under these conditions and associated mechanical behaviors are described. During conventional discontinuous (dDRX) that takes at elevated temperatures, grains evolve nucleation growth in materials with low to medium stacking fault energies (SFE). On other hand, ultrafine can be any material...
Abstract Structure evolution taking place in pure polycrystalline copper was studied multiple compressions at room temperature. Rectangular samples were compressed with consequent change the loading direction from pass to pass. The deformation behaviour high strains of above 2 shows an apparent steadystate flow following a rapid rise stress early stage deformation. structural changes are characterized by many mutually crossing subboundaries low moderate strains, finally followed development...
The microstructural changes leading to nanocrystalline structure development and the respective tensile properties were studied in a 304L stainless steel subjected large strain cold rolling at ambient temperature. was accompanied by of deformation twinning martensitic transformation. latter readily occurred microshear bands, martensite fraction approach 0.75 total 3. followed banding transformation promoted consisting uniform mixture austenite grains with their transverse sizes 120–150 nm....