A5109148270- Fuel Cells and Related Materials
- Electrocatalysts for Energy Conversion
- Advanced Battery Technologies Research
- Electric Vehicles and Infrastructure
- Anodic Oxide Films and Nanostructures
- Electrospun Nanofibers in Biomedical Applications
- Hydrogen Storage and Materials
- Power System Reliability and Maintenance
- Optical Coatings and Gratings
- Vascular Tumors and Angiosarcomas
- Ultrasound Imaging and Elastography
- Advanced battery technologies research
- Power Transformer Diagnostics and Insulation
- Photoacoustic and Ultrasonic Imaging
- Ultrasound and Hyperthermia Applications
- Corrosion Behavior and Inhibition
- Cyclone Separators and Fluid Dynamics
- Photonic and Optical Devices
- Electric and Hybrid Vehicle Technologies
- Hydrogen embrittlement and corrosion behaviors in metals
- Energy Load and Power Forecasting
National Cheng Kung University
2017
Yuan Ze University
2013-2014
Chang Gung University
2006
A two-dimensional (2D) grating guided-mode resonance (GMR) tunable filter is experimentally demonstrated using a low-cost two-step nanoimprinting technology with one-dimensional (1D) polydimethylsiloxane mold. For the first nanoimprinting, we precisely control UV LED irradiation dosage and demold device when glue partially cured 1D mold then rotated by three different angles, 30°, 60°, 90°, for second to obtain 2D structures crossing angles. high-refractive-index film ZnO coated on surface...
This paper proposes a high-efficiency and compact fuel cell–battery hybrid power system without DC/DC converters. Generally, cells supply to charge lithium batteries or loads using The disadvantages of converter are its complex design, poor efficiency, large volume. Therefore, improvements in the volume, weight, efficiency main objectives proposed topology, which is suitable for stable operation equipment. novel topology converters forklift analyzes, discusses, verifies it with experimental...
This paper aims to apply the bio-inspired intelligent techniques optimize maintenance scheduling of transformers. The study is enhanced with aid forest optimization algorithm reach a schedule reduced failure rate and decreased insulation life loss To verify effectivity this approach, method tested on real distribution system consisting 48 Test results confirm that proposed feasible effective.
In order to produce low-cost flow field plates for polymer electrolyte membrane fuel cells, we used nickel foam in this study rather than conventional field. Nickel has high electron conductivity, thermal and mechanical strength. Electrochemical impedance spectrum analysis is carried out evidence the use on of foam. From fitting results, cases showed lower contact resistance serpentine. However, such have poor performance at low temperatures ambient pressure. overcome this, a multi-segment...