A5055781070- Adhesion, Friction, and Surface Interactions
- Gear and Bearing Dynamics Analysis
- Structural Response to Dynamic Loads
- High-Velocity Impact and Material Behavior
- Additive Manufacturing Materials and Processes
- Mechanical stress and fatigue analysis
- Metal and Thin Film Mechanics
- Mechanical Behavior of Composites
- Tribology and Lubrication Engineering
- Welding Techniques and Residual Stresses
- Structural Integrity and Reliability Analysis
- Additive Manufacturing and 3D Printing Technologies
- Heat Transfer and Boiling Studies
- Sports Dynamics and Biomechanics
- Acoustic Wave Phenomena Research
- Geotechnical Engineering and Underground Structures
- Mine drainage and remediation techniques
- Membrane Separation Technologies
- Electrical Contact Performance and Analysis
- Heat Transfer Mechanisms
- Advanced Measurement and Detection Methods
- High-Temperature Coating Behaviors
- Advanced materials and composites
- Erosion and Abrasive Machining
- High voltage insulation and dielectric phenomena
Nanyang Technological University
2020-2024
Inner Mongolia University of Technology
2020-2022
Henan Polytechnic University
2022
Wuhan University of Technology
2017-2018
Tianjin University
2018
Collaborative Innovation Centre for Advanced Ship and Deep-Sea Exploration
2017
The increasing concern about noise pollution has accelerated the development of acoustic absorption and damping devices. However, conventional subtractive manufacturing can only fabricate devices with simple geometric shapes that are unable to achieve high coefficients in wide frequency ranges. In this paper, novel multi-layer micro-perforated panels (MPPs) tunable wideband designed fabricated by 3D printing or additive manufacturing. Selective laser sintering (SLS), which is an advanced...
This paper studies the stiffening effects of material strain rate sensitivity and hardening on saturated impulse elastic, perfectly plastic plates. Finite element (FE) code ABAQUS is employed to simulate elastoplastic response square plates under rectangular pressure pulse. Rigid-plastic analyses for impulse, which consider hardening, are conducted. Satisfactory agreement between finite models (FEM) predictions rigid-plastic analysis obtained, verifies that proposed methods effective solve...
This article presents the application of a computational fluid dynamics (CFD) finite volume method (FVM) model for thermo-mechanical coupling simulation weld pool used in variable polarity plasma arc welding (VPPAW). Based on mechanism additional pressure produced through self-magnetic compression and jet generated from mechanical compression, considering influence height keyhole secondary pressure, three-dimensional transient (VPPA) was established. The material flow behaviors perforated...
A finite element model for the non-Newtonian starved thermal-elastohydrodynamic lubrication of 3D line contact is developed. The integrates mutually dependent solutions pressure, film thickness, and temperature in a coupled system. difference Elrod algorithm introduced constructed solution scheme to realize starvation condition determine fractional content. lubricant velocity shear rate three typical lubricants are derived by using separation flow method. interacted sequentially determined...
Abstract This study presents a numerical model for the thermal-elastohydrodynamic lubrication of heterogeneous materials in impact motion, which rigid ball bounces on starved non-Newtonian oil-covered plane surface an elastic semi-infinite solid with inhomogeneous inclusions. The impact–rebound process and microscopic response subsurface inclusions are investigated. homogenized according to Eshelby’s equivalent inclusion method. Elrod algorithm is adopted determine starvation based solutions...
Freshwater scarcity is a pressing issue worldwide, and solar steam generators (SSGs) have emerged as promising device for seawater desalination, harnessing renewable energy to facilitate sustainable water evaporation. The facile fabrication approach SSG with complex topologies achieve high evaporation efficiency remains challenge. Herein, MIL-101 (Fe)-derived C@Fe3O4 ink was employed multi-jet fusion (MJF) printing of polymeric porous SSGs specific topologies. optimized structure endows the...