A5065689978- Mechanical Behavior of Composites
- Interconnection Networks and Systems
- Geotechnical Engineering and Soil Stabilization
- Fiber-reinforced polymer composites
- Geotechnical Engineering and Underground Structures
- Structural Analysis of Composite Materials
- Composite Structure Analysis and Optimization
- Robotic Mechanisms and Dynamics
- Geotechnical Engineering and Analysis
- Metal Forming Simulation Techniques
- Composite Material Mechanics
- Structural Analysis and Optimization
- Structural Response to Dynamic Loads
- Structural Load-Bearing Analysis
- Advanced Optical Network Technologies
- Manufacturing Process and Optimization
- Additive Manufacturing and 3D Printing Technologies
- Laser and Thermal Forming Techniques
- Distributed systems and fault tolerance
- Evolutionary Algorithms and Applications
- Cloud Computing and Resource Management
- Geotechnical Engineering and Soil Mechanics
- Structural Behavior of Reinforced Concrete
- Software Engineering Techniques and Practices
- Metallurgy and Material Forming
Birla Institute of Technology and Science, Pilani
2015-2024
KR Mangalam University
2015-2020
Synergy University Dubai
2012-2013
National Institute of Technology Karnataka
2013
Birla Institute of Technology and Science, Pilani - Dubai Campus
2013
Indian Institute of Technology Bombay
2011
Central Silk Technological Research Institute
2011
University of Mysore
2011
Indian Institute of Technology Madras
1993-2011
National Institute of Technology Rourkela
2011
Abstract The reduction in fiber length during extrusion and injection molding of two commercial glass fiber‐reinforced polypropylene products containing 30 percent by weight fibers was studied. first product had very small average around 0.5 mm also contained a coupling agent. second relatively longer 9 no In both cases, attrition occurs predominantly at the solid‐melt interface meiting zone extruder. However, short granules, maximum distribution, which for initial sample is mm, moved to...
Abstract Two commercial grades of glass fiber‐reinforced polypropylene granules, one containing short fibers average length around 0.5 mm with a coupling agent and the other relatively much longer mostly 9 mm, but no agent, were injection‐molded into dumbbells tested in tension between −43 90°C. There is considerable fiber attrition during injection molding; lengths are reduced to values 0.4 0.8 for thses two samples. Also molding test sample, partial molecular alignment matrix...
An improved high-order theory is presented to investigate the dynamic behavior of thin and thick fiber-reinforced plastic (FRP) plates with a soft viscoelastic flexible core. Shear deformation used for face sheets while three-dimensional elasticity The analysis permits nonlinear distortions cross-sectional plane core as well changes in its height. determines damped natural frequencies, loss factors, local global mode shapes plates. Some results are hitherto not reported literature based on...