A5050094131- Probabilistic and Robust Engineering Design
- Structural Health Monitoring Techniques
- Advanced Multi-Objective Optimization Algorithms
- Model Reduction and Neural Networks
- Mechanical stress and fatigue analysis
- Structural Load-Bearing Analysis
- Structural Behavior of Reinforced Concrete
- BIM and Construction Integration
- Petroleum Processing and Analysis
- Fluid dynamics and aerodynamics studies
- Manufacturing Process and Optimization
- Metallurgy and Material Forming
- Shape Memory Alloy Transformations
- Spacecraft and Cryogenic Technologies
- Hydrogen embrittlement and corrosion behaviors in metals
- Heat Transfer and Optimization
- CO2 Sequestration and Geologic Interactions
- Methane Hydrates and Related Phenomena
- Metaheuristic Optimization Algorithms Research
- Surface Modification and Superhydrophobicity
- Corrosion Behavior and Inhibition
- Structural Engineering and Vibration Analysis
- Hydraulic Fracturing and Reservoir Analysis
- Seismic Performance and Analysis
- Microstructure and Mechanical Properties of Steels
Anhui Science and Technology University
2021-2024
Anhui University of Science and Technology
2021-2024
Jiangsu University
2020-2021
Research Institute of Petroleum Exploration and Development
2010
Surrogate models are widely used in engineering design and optimization to substitute computationally expensive simulations for efficient approximation of system behaviours. However, since actual behaviours usually not known a priori, it is very challenging select the most appropriate surrogate model specific application. To tackle this, ensemble that combine different have been developed based on global measures local respectively. This article proposes novel surrogates take advantage both...
Reinforced concrete (RC) is the result of a combination steel reinforcing rods (which have high tensile) and has compressive strength). Additionally, prediction long-term deformations RC flexural structures magnitude influence relevant material geometric parameters are important for evaluating their serviceability safety throughout life cycles. Empirical methods predicting deformation limited due to difficulty considering all influencing factors. In this study, four popular surrogate models,...
There have been a large number of research programs dedicated to the investigation stress concentration factor and its parametric design formulae for variety uniplanar multiplanar tubular joints. However, overlapped joints, related reports are very limited due fact that combining effect between multiplanarity brace overlapping is quite complex. In this paper, novel bracket‐stiffened two‐planar KT‐joint proposed by adding two brackets upper diagonal horizontal braces alleviate at...
A large number of criteria to model the onset plasticity for ductile metals have been proposed by researchers in last century. Strangely, very few tried stress-induced crystalline phase transformation Shape Memory Alloys (SMAs) according yield criteria. This paper focuses on question: is a criterion originally describing plastic behavior suitable “pseudoelastic” SMAs? To answer this question, two present author are used predict initial surface different SMAs: Cu-Al-Be and Ni-Ti alloy. The...
Abstract Liquid surface tension is produced at interfaces between liquid and air, due to the different molecular attractions on both sides. If adhesion a solid wall greater than cohesion of itself, rises in concave form action tension, near produces suction head. Conversely, if liquid-solid less liquid, drops down convex has pressure This paper systematically investigates shape distributions static liquids walls. The scenarios investigated walls double vertical plates. For plane-based...