A5101642402- Analog and Mixed-Signal Circuit Design
- Radio Frequency Integrated Circuit Design
- Advancements in Semiconductor Devices and Circuit Design
- Advanced materials and composites
- Advanced ceramic materials synthesis
- Microwave-Assisted Synthesis and Applications
- Advanced Machining and Optimization Techniques
- Muscle activation and electromyography studies
- Healthcare cost, quality, practices
- Lightning and Electromagnetic Phenomena
- Prosthetics and Rehabilitation Robotics
- Acoustic Wave Resonator Technologies
- Microscopic Colitis
- Underwater Vehicles and Communication Systems
- Electrical Fault Detection and Protection
- Vitamin D Research Studies
- Electromagnetic Compatibility and Noise Suppression
- Anatomy and Medical Technology
- Lower Extremity Biomechanics and Pathologies
- Electrostatic Discharge in Electronics
- Knee injuries and reconstruction techniques
- High voltage insulation and dielectric phenomena
- Sports injuries and prevention
- GaN-based semiconductor devices and materials
- MXene and MAX Phase Materials
Sarojini Naidu Medical College
2024
Maulana Azad National Institute of Technology
2023
Indian Institute of Technology Roorkee
2023
King George's Medical University
2023
Indian Institute of Science Bangalore
2021
Netaji Subhas University of Technology
2020
Background Vitamin D deficiency is prevalent globally, with potential consequences for bone health and trauma outcomes. This study aimed to assess the prevalence of vitamin in orthopedic patients investigate its correlation various demographic injury-related factors. Methodology A cross-sectional investigation was undertaken at a tertiary care center. An evaluation serum 25-hydroxyvitamin D3 levels conducted on 124 individuals, aged 20 70 years, who were hospitalized injuries. Demographic...
The quadriceps angle, commonly known as the Q-angle, is angle formed between vectors of pull muscle and patellar tendon. literature varies in terms values Q angles measured by various researchers. It well appreciated that normal Q-angle should fall 12° 20°, with males being at lower end this range females having higher measurements. An increase beyond has been associated knee extensor dysfunction leading to instability. Keeping mind clinical biomechanical importance aim study was compare...
In this article a new electronically controllable grounded frequency-dependent negative resistance (FDNR) simulation circuit is proposed. The presented employs two voltage differencing current conveyors (VDCCs), capacitances and one resistance. proposed configuration simulates FDNR without any requirement of component matching enjoys the electronic control through transconductances VDCCs. exhibit excellent non-ideal behavior low values sensitivity figures. high frequency limitation realized...
This research article proposes a new grounded frequency dependent negative conductance (FDNC) simulator. The presented simulator is designed by employing two voltage differencing trans-conductance amplifiers (VDTAs) along with capacitances. FDNC enjoys electronic controllability of realized no component matching constraints and exhibits excellent behavior under non-ideal conditions low active/passive sensitivity indexes. working has been verified some mode filter design examples. performance...
In recent times, High Voltage DC transmission systems have played an integral role in transmitting a massive amount of electrical energy over very long distances economically. As the system is exposed to environment, it prone lightning surges and atmospheric stresses leading insulation damage. Metal oxide surge arresters are widely used for protecting power from surges. The polymer housing arrester has several advantages ceramic housing. However, was reported that affected by environmental...
This research paper proposes a new circuit configuration which can act like grounded impedance simulator/grounded scaling circuit. The presented simulate electronically tunable resistance/capacitance/inductance/FDNR and also work as multiplier circuit, scale-up/scale-down the value of arbitrary with an controllable multiplication factor. proposed employed three voltage difference trans-conductance amplifiers along passive elements. use elements makes this realization suitable for monolithic...
This research paper presents a new floating frequency-dependent negative resistance (FDNR) simulation configuration with electronic tuning facility. The proposed circuit is constructed by employing three voltage differencing transconductance amplifier (VDTAs) and two grounded capacitances. Employment of only capacitances provides easy monolithic integration this circuit. simulated can be tune electronically bias currents used VDTAs. presented does not have any requirement matched passive...
This research article details the development of a Bluetooth-controlled 3D printed hand prosthetic using MIT App Inventor and polylactic acid (PLA) material through fused filament fabrication (FFF) technology. The aim study was to create functional that could be wirelessly controlled smartphone application while keeping cost low. Motion achieved servo motors by microcontroller via Bluetooth, with voice commands sliders available on app. use FFF technology allowed for greater customization,...