Removal of copper (II) by manganese-coated sand in a liquid fluidized-bed reactor

• DOI: 10.1016/j.jhazmat.2004.06.033
• Publication Date: 2004-09-29T15:08:38Z
• Authors: C LEE; W YANG; C HSIEH
• Keywords: Manganese; Surface Properties; Color; 02 engineering and technology; Hydrogen-Ion Concentration; Silicon Dioxide; Waste Disposal, Fluid; 6. Clean water; Thermodynamics; Adsorption; 0210 nano-technology; Copper; Filtration; Water Pollutants, Chemical

This study was performed in a fluidized-bed reactor (FBR) filled with manganese-coated sand (MCS) to treat copper-contaminated wastewater. The adsorption characteristics of MCS, the adsorption equilibrium of MCS, and the copper removal capacity by MCS in FBR were investigated. In terms of the adsorption characteristics of MCS, the surface of MCS was evaluated using a scanning electron microscope (SEM). Energy dispersive analysis (EDS) of X-rays indicated the composition of MCS, and the quantity of manganese on MCS was determined by means of acid digestion analysis. The experimental results indicated that copper was removed by both sorption (ion exchange and adsorption) and coprecipitation on the surface of MCS in FBR. Copper removal efficiency was highly dependent on the pH and increased with increasing pH from pH 2 to 8. After the copper adsorption by MCS, the pH in solution was decreased. When the MCS concentration was greater than 10 g/l, the copper adsorptivities obtained by FBR were almost the same as that from the shaker and when the MCS concentration reached 40 g/l, the copper adsorptivity in FBR was greater than that from the shaker. The adsorption sites of MCS could be used efficiently by the FBR. A Langmuir adsorption isotherm equation fit the measured adsorption data from the batch equilibrium adsorption test better than the Freundlich adsorption isotherm equation did. In addition, the adsorption rate increased when the influent wastewater was aerated.