Influence of Different Modifiers on Bonding Strength and Rheological Performance of Bitumen Emulsion

• DOI: 10.3390/ma12152414
• Publication Date: 2019-07-29T07:06:58Z
• Authors: Changluan Pan; Deqiang Liang; Liantong Mo; Martin Riara; Juntao Lin
• Keywords: 13. Climate action; rheological property; bonding strength; 0211 other engineering and technologies; emulsion modification; 02 engineering and technology; bitumen emulsion; Article; 0201 civil engineering

Styrene butadiene rubber latex (SBR), waterborne epoxy adhesive (WE) and colloidal silica sol (SiO2) were used to prepare modified bitumen emulsion for cold mix asphalt. The modification effects of the individual modifiers and the combination of these modifiers were investigated by using bonding strength and dynamic shear rheological property. Test results showed that the modifier dosage helped to balance the performance of modified bitumen emulsion by improving its bonding strength without compromising its rheological properties. The critical dosage at which the peak bonding strength occurred was 4%, 12% and 4% for SBR, WE and SiO2 respectively. Improved rheological performance on the master curves was well distinguished, in particular, by increased complex modulus and reduced phase angle at the low frequency region. Abrupt changes, especially on phase angle occurred when the modifier dosage was beyond 12%. The measured ratio between bonding strength and complex shear modulus could vary ranging from 10−2 to 102. Highly-modified bitumen emulsion with good adhesion, rheology and compatibility can be prepared by using the combination of SBR, WE and SiO2. It is important to carefully select the type and dosage of modifier for a particular combination to optimize the performance of modified bitumen emulsion.