A5005642553- Adsorption and biosorption for pollutant removal
- Pharmaceutical and Antibiotic Environmental Impacts
- Plant Surface Properties and Treatments
- Analytical chemistry methods development
- Microplastics and Plastic Pollution
- Phosphorus and nutrient management
- Aquaculture Nutrition and Growth
- Horticultural and Viticultural Research
- Botanical Research and Applications
- Electrohydrodynamics and Fluid Dynamics
- Lignin and Wood Chemistry
- Advanced Fiber Laser Technologies
- Membrane Separation Technologies
- Photonic and Optical Devices
- Advanced Fiber Optic Sensors
- Nanomaterials for catalytic reactions
- Analytical Chemistry and Sensors
- Material Properties and Processing
- Rabbits: Nutrition, Reproduction, Health
- Clay minerals and soil interactions
- Thermochemical Biomass Conversion Processes
- Public Health and Environmental Issues
- Postharvest Quality and Shelf Life Management
- Dye analysis and toxicity
- Pickering emulsions and particle stabilization
Universidade do Porto
2012-2021
Rede de Química e Tecnologia
2021
University of Aveiro
2014-2018
Instituto de Investigación en Recursos Cinegéticos
2016
Trent University
2016
A charcoal was produced from primary pulp mill sludge and then used for the adsorptive removal of diclofenac, salicylic acid, ibuprofen acetaminophen. main aim to assess utilization this material tertiary treatment sewage. For purpose, adsorption selected pharmaceuticals secondary effluent a sewage plant (STP) compared with their ultrapure water. Differences in kinetics equilibrium were evident between four considered. However, differences two aqueous matrixes considered negligible. It...
This study evaluates the possibility of adding value to cork granulates, byproducts processing, by using them as biosorbents and precursors activated carbons. Activation was carried out impregnation with phosphoric acid followed pyrolysis under N2 flow. Furthermore, were treated a cationic surfactant carbons subject second propene objective improving hydrophobicity. Physico-chemical, textural, surface characterization materials employing, among others, adsorption isotherms, Fourier transform...
A reflective fiber optic sensor based on multimode interference for the measurement of refractive index variations in glucose aqueous solutions is proposed. The fabricated by splicing a short section coreless silica to standard single mode fiber. influence dimensions performance analyzed. By changing length, no significant impact observed. However, reduction sensing head diameter leads large improvement sensitivity. smaller sensor, with length 5 mm and 24 μm, presents maximum sensitivity...
The scope of this work is to evaluate the recyclability potential hardwood and softwood unbleached kraft pulps, leading a sound basis for comparison even support decision about fibers according performance achieved. influence successive recycling cycles (up 10 cycles) on fiber morphology, pulp suspension drainability, water retention capacity, handsheet mechanical properties were studied Eucalyptus globulus Pinus sylvestris pulps. these pulps as linerboard corrugating medium packaging was...
A supramolecular atropine sensor was developed, using cucurbit[6]uril as the recognition element. The solid-contact electrode is based on a polymeric membrane incorporating (CB[6]) an ionophore, 2-nitrophenyl octyl ether solvent mediator, and potassium tetrakis (4-chlorophenyl) borate additive. In MES-NaOH buffer at pH 6, performance of characterized by slope (58.7 ± 0.6) mV/dec with practical detection limit (6.30 1.62) × 10−7 mol/L lower linear range (1.52 0.64) 10−6 mol/L. Selectivity...
Get PDF Email Share with Facebook Tweet This Post on reddit LinkedIn Add to CiteULike Mendeley BibSonomy Citation Copy Text S. Novais, C. I. A. Ferreira, M. and J. L. Pinto, "Glucose Measurements Optical Fiber Sensor based Coreless Silica Fiber," in 26th International Conference Sensors, OSA Technical Digest (Optica Publishing Group, 2018), paper ThE2. Export BibTex Endnote (RIS) HTML Plain alert Save article