A5072568236- Magnesium Alloys: Properties and Applications
- Aluminum Alloys Composites Properties
- Microstructure and mechanical properties
- Metal and Thin Film Mechanics
- Additive Manufacturing Materials and Processes
- Titanium Alloys Microstructure and Properties
- Metallic Glasses and Amorphous Alloys
- Corrosion Behavior and Inhibition
- Aluminum Alloy Microstructure Properties
- Welding Techniques and Residual Stresses
- Electrodeposition and Electroless Coatings
- Reservoir Engineering and Simulation Methods
- Crystallography and molecular interactions
- Hydraulic Fracturing and Reservoir Analysis
- Mineral Processing and Grinding
- Force Microscopy Techniques and Applications
- Metallurgy and Material Forming
- Metal-Organic Frameworks: Synthesis and Applications
- High Entropy Alloys Studies
Southern University of Science and Technology
2019-2024
University of Birmingham
2019-2024
Daqing Oilfield General Hospital
2012
Rapid advances in the engineering application prospects of metal-organic framework (MOF) materials necessitate an urgent in-depth understanding their mechanical properties. This work demonstrates unprecedented recoverable elastic deformation Ni-tetraphenylporphyrins (Ni-TCPP) MOF nanobelts with a tensile strain as high 14%, and projected yield strength-to-Young's modulus ratio exceeding theoretical limit (≈10%) for crystalline materials. Based on first-principles simulations, observed...
The effect of yttrium (Y) on the critical resolved shear stresses (CRSS) < a > basal slip, {101¯2}⟨1¯011⟩ tension twinning and c + pyramidal slip has been studied using micro-pillar compression tests along selected orientations at room temperature, two magnesium (Mg) alloys with different Y contents (0.4 4 wt.%). CRSS increased slightly from 30 ± 1 MPa (for Mg-0.4Y) to 37 3 Mg-4Y). In Mg-0.4Y, stress activate twin was determined be 45 12 MPa, while in Mg-4Y it 113 MPa. compressed samples...
The appearance of thin film metallic glasses (TFMGs) is gaining increasing interest because their unique mechanical and anticorrosion properties potential engineering applications. In this study, Cu–Zr–Al ternary were fabricated by using DC magnetron sputtering equipment with various target powers. evolution the structure was systematically investigated grazing incidence X-ray diffractometer, scanning electron microscopy, transmission microscopy. deposition rate increases applied power....
For low permeability and inhomogeneous reservoirs, defective effects such as water content increasing are usually resulted from traditional acidization. The principle of temporary plugging - acidization in Low well selection treatment requirements introduced this article. agent selected laboratory was used for field experiment. Result shows that: wells multiplayer thin interlayer, – technique can acidify the formation by subsequence high to permeability, thus significantly increase...