A5101429969- Organic Electronics and Photovoltaics
- Conducting polymers and applications
- Thin-Film Transistor Technologies
- Integrated Circuits and Semiconductor Failure Analysis
- Nuclear Materials and Properties
- Nanowire Synthesis and Applications
- Radioactive element chemistry and processing
- Advanced Surface Polishing Techniques
- Optical Coatings and Gratings
- Microwave Dielectric Ceramics Synthesis
- Organic Light-Emitting Diodes Research
- Chemical Synthesis and Characterization
- Speech and Audio Processing
- Music and Audio Processing
- Advanced Sensor and Energy Harvesting Materials
- Advanced ceramic materials synthesis
- Silicone and Siloxane Chemistry
- Speech Recognition and Synthesis
Lam Research (United States)
2021
Chinese Academy of Sciences
2015-2021
University of Chinese Academy of Sciences
2013-2021
Institute of Microelectronics
2021
Shanghai Institute of Applied Physics
2021
Harbin Institute of Technology
2016
Changchun Institute of Applied Chemistry
2015
State Key Laboratory of Polymer Physics and Chemistry
2015
Speaker identification is a classification task which aims to identify subject from given time-series sequential data. Since the speech signal continuous one-dimensional time series, most of current research methods are based on convolutional neural network (CNN) or recurrent (RNN). Indeed, these perform well in many tasks, but there no attempt combine two models study speaker task. Due spectrogram that contains, spatial features voiceprint (which corresponds voice spectrum) and CNN...
Although conventional laser ablation (CLA) method has widely been used in patterning of organic semiconductor thin films, its quality control still remains unsatisfied due to the ambiguous photochemical and photothermal processes. Based on industrial available near-infrared source, herein, a novel “layer-filter threshold” (LFT) technique is proposed, which involves decomposition targeted “layer-filter” subsequent explosive evaporation process purge away upper layers instead layer-by-layer...
Process optimization is a required step during semiconductor technology pathfinding and device evaluation. Virtual process modeling 3D fabrication tools can be used to study diagnostic, predictive, prescriptive of windows accelerate integration. These virtual techniques will become especially valuable as novel gate-all-around devices (GAA) are introduced replace state-of-the-art FinFET technologies. Model calibration needed ensure the accuracy any model requires wafer-based metrology data....
Owing to many problems of the detriment by large amount organic reagents, high cost and difficulty industrialization, development high-efficiency economical technologies for uranium extraction is an irresistible trend support steady supply nuclear energy. Herein, a novel fibrous adsorbent, named as AO-HPE fibers, was prepared introduction amidoxime groups using green vapor-phase grafting polymerization (VPGP) technology monomer acrylonitrile (AN). Gaseous AN grafted onto ultra molecular...
A series of brominated polystyrenes (BPSs) are readily synthesized and blended as polymer dopants with the p‐type semiconducting polymer, poly(3‐hexylthiophene) (P3HT), to improve theirelectrical performance. The obtained P3HT/BPS blend films exhibit increased carrier concentration resulting from doping P3HT by BPS, which leads excellent electrical performance, including enhanced hole mobility conductivity, conductivity or increases bromination degree BPS. Compared conventional small...
An interface modification strategy based on a hybrid cathode buffer layer is proposed and demonstrated for promoting charge generation extraction.