A5009051090- Surface Modification and Superhydrophobicity
- Metal-Organic Frameworks: Synthesis and Applications
- Electrospun Nanofibers in Biomedical Applications
- Machine Learning in Materials Science
- Structural Behavior of Reinforced Concrete
- Covalent Organic Framework Applications
- Carbon dioxide utilization in catalysis
- Network Security and Intrusion Detection
- Anomaly Detection Techniques and Applications
- Surface Treatment and Residual Stress
- Geotechnical Engineering and Underground Structures
- Energy Load and Power Forecasting
- Spacecraft and Cryogenic Technologies
- Complex Network Analysis Techniques
- Geophysics and Sensor Technology
- Silicon Nanostructures and Photoluminescence
- Fluid Dynamics and Heat Transfer
- Microstructure and mechanical properties
- Catalysis and Oxidation Reactions
- Grey System Theory Applications
- Adsorption and biosorption for pollutant removal
- Catalytic Processes in Materials Science
- TiO2 Photocatalysis and Solar Cells
- Structural Load-Bearing Analysis
- High voltage insulation and dielectric phenomena
Institute of Vegetables and Flowers
2025
Chinese Academy of Agricultural Sciences
2025
Ministry of Agriculture and Rural Affairs
2025
Shenyang Institute of Automation
2023-2025
Dalian University of Technology
2017-2024
Chinese Academy of Sciences
2020-2023
Southwestern University of Finance and Economics
2023
China University of Mining and Technology
2014-2022
Dalian University
2017-2021
Northeast Petroleum University
2016-2019
Numerical researches concerning various outcomes during single liquid droplet impact on tubular surfaces with different hydrophobicity values are carried out using a coupled level set and volume-of-fluid method. The velocities studied in this paper 0.1 m/s, 0.5 0.94 1.2 respectively. contact angles of the tube 107°, 120°, 135°, 153°, It is found that, when velocity constant, increase surface detrimental to spread film surfaces. larger angle, more likely rebound takes place. For constant...
In this paper, an improved Extreme Gradient Boosting (XGBoost) algorithm based on the Graph Isomorphic Network (GIN) for predicting adsorption performance of metal-organic frameworks (MOFs) is developed. It shown that graph isomorphic layer can directly learn feature representation materials from connection atoms in MOFs. Then, XGBoost be used to predict MOFs representation. sense, it not only possible achieve end-to-end prediction structure but also ensure accuracy prediction. The...
This work mainly involved the investigation of adsorption thiophene on Pt/Ag-supported activated carbons (ACs) prepared by ultrasonic-assisted impregnation (UI). The capacity over ACs studied followed order Pt/Ag/AC-UI > Ag/AC-UI Ag/AC AC Pt/AC. Pt ions can promote reaction between soft acid Ag(I) and base thiophene. These sorbents were characterized X-ray diffraction (XRD), sorption nitrogen (BET), thermal analysis.
Activated carbons (ACs) derived from coconut husk were modified by impregnating with glycine, a non-polar fatty amino acids. The effect of this modification method on the physicochemical characteristics ACs and adsorption performance VOC investigated compared ammonia modification. TEM, SEM BET used to identify morphology pore structure, XPS elemental analysis applied analyze surface chemistry tested ACs. selected toluene was using fixed-bed reactor. results show that breakthrough capacity...
This research presents the detailed application of pressure bulb theory in optimising gateroad layout under remnant chain pillar longwall undermining technology with assistance numerical simulation FLAC3D®. Prior to extracting underlying seam, threshold corresponding minimum offset distance is determined; optimal maximum principle stress (MaxPS) as well shear (MaxSS) predicts segment. After extracted subsequent two indicators peak normalised rib abutment and width yield zone are employed...
Metal–organic frameworks (MOFs) are considered one of the most important materials for carbon capture and storage (CCS) due to advantages porosity, multifunction, diverse structure, controllable chemical composition. With continuous development artificial intelligence (AI) technology, more machine learning models used identify MOFs with high performance within a massive search space. However, current works have yet form model that uses graph-structured data only, which can predict adsorption...
Introduction: As an efficient energy transfer technology, the gas wave ejector (GWE) holds several patents poised to address challenges of low-carbon energy. These find applications in numerous fields. Traditional axial-flow GWE encounter limitations under certain application conditions, whereas radial-flow offer effective solution these issues. However, mechanisms behind performance differences between two types GWEs have not yet been studied. Objective: Since pressure waves are central...
Fiber Bragg grating (FBG) measuring bolts, as a useful tool to evaluate the behaviors of steel bolts in underground engineering, can be manufactured by gluing FBG sensors inside grooves, which are usually symmetrical cuts along bolt rod. The selection cut shape and glue types could perceivably affect final supporting strength bolts. Unfortunately, impact type on bolting is not yet clear. In this study, based direct tension tests, full tensile load⁻displacement curves rock with different...
By means of a pipe's inner surface grinding, single-phase nanostructured austenite was formed on the an AISI 304 stainless steel. The electrochemical corrosion behavior compared with coarse-grained counterpart identical roughness. Experimental results show that shows higher pitting potential and wider passivation interval than those its counterpart. enhanced resistance attributed to fast diffusion Cr within nanostructure and, hence, formation thicker passive film efficiently protect against...
The exploration of hot dry rock (HDR) geothermal resources in the Gonghe Basin Qinghai Province plays a vital role promoting development clean energy future. As new type energy, HDR resource is more environmentally friendly than other fossil fuels. Therefore, it practically significant to detect where reservoir located. physical characteristics assemble viscoelastic medium, wave field simulation method based on low rank approximation used study it. One advantage this that attenuation seismic...