N. Said

ORCID: 0000-0002-7114-2247
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • Biodiesel Production and Applications
  • Lubricants and Their Additives
  • Catalysis and Hydrodesulfurization Studies
  • Petroleum Processing and Analysis
  • Fluid Dynamics and Mixing
  • Advanced Combustion Engine Technologies
  • Electrohydrodynamics and Fluid Dynamics
  • Biological Research and Disease Studies
  • Architectural and Urban Studies
  • Fuel Cells and Related Materials
  • Algal biology and biofuel production

Politeknik Negeri Ujung Pandang
2015-2022

University of Technology Malaysia
2018

European Thermodynamics (United Kingdom)
2015

The need for fossil fuels and the emissions generated from these are increasing daily.Researchers concerned with global warming as well climate change; energy sustainability material usages important issues today.Waste cooking oil (WCO) can be processed into biodiesel an alternative fuel to replace diesel.Production of using WCO feedstock has been growing interest last two decades.A number research papers related improvements in production, raw materials catalyst selection have...

10.15282/jmes.8.2015.5.0127 article EN cc-by-nc JOURNAL OF MECHANICAL ENGINEERING AND SCIENCES 2015-06-30

The production of activated carbon from agricultural waste is one the most environmental-friendly solutions by converting into valuable material. In this study, Areca catechu husk converted to remove methylene blue (MB) dye in aqueous solution. This Catechu was impregnated with phosphoric acid (H3PO4) an ultrasonic bath for 30 minutes activate a pore surface before undergo carbonization at temperature 700 ℃ 2 hours. physicochemical properties characterized ash content, moisture bulk density,...

10.24191/joa.v13i1.4586 article EN cc-by 2025-04-30

Antioxidants play critical roles in cellular defence mechanisms both enzymatic and non-enzymatic forms within the intracellular extracellular environments. While microalgae are recognised as a rich source of antioxidants, limited information is available on species native to Peninsular Malaysia that contain high antioxidant capacity for future applications. This study aimed assess antioxidants microalgae, particularly those cultivated locally Malaysia, which still scarce. Nineteen collected...

10.47836/pjtas.48.1.04 article EN Pertanika journal of tropical agricultural science 2025-01-27

The use of waste cooking oil (WCO) as feedstock and in microwave heating technology helps to reduce the cost biodiesel.In this study, a continuous flow transesterification by irradiation for biodiesel production using calcium oxide (CaO) aheterogeneous catalyst, calcined from cockle shells, is used.The catalyst was packed inside plastic perforated container mounted on stirrer shaft inserted reactor.The thermocouple reactor connected temperature controller power input maintain...

10.14716/ijtech.v9i2.1386 article EN cc-by-nc-nd International Journal of Technology 2018-04-27

The use of Waste Cooking Oil (WCO) as feedstock, and microwave heating technology are favored to reduce the cost biodiesel. In order identify effect using biodiesel from WCO Methyl Ester (WCOME) blends on diesel engine emissions performance, WCOME were tested in a single-cylinder Direct Injection (DI) at constant speed 2500 rpm with five loads. For comparison, commercial fuel, Petron Diesel Max (PDM), mixture palm oil (POME) also used. performance emission test results fuels: PDM, BP10,...

10.14716/ijtech.v9i2.1204 article EN International Journal of Technology 2018-04-27

In general, the Rooftop PV Panel installation only considers power capacity to be installed and available roof area. It does not consider type of material where it is installed. Meanwhile, house has absorption sunlight different thermal properties depending on roofing material. this study, objective research observe temperature characteristics between solar panels roofs from 2 types materials, namely clay tile ceramic tile, influence height panel ceiling its effect efficiency panel. Based...

10.15866/ireme.v16i3.20004 article EN International Review of Mechanical Engineering (IREME) 2022-03-31
Coming Soon ...