A5058706120- Aluminum Alloy Microstructure Properties
- Microstructure and mechanical properties
- Aluminum Alloys Composites Properties
- Structural Analysis and Optimization
- Topology Optimization in Engineering
- Welding Techniques and Residual Stresses
- Composite Structure Analysis and Optimization
- Structural Load-Bearing Analysis
- Vibration and Dynamic Analysis
- Metallurgy and Material Forming
- Advanced Welding Techniques Analysis
- Advanced Materials and Mechanics
- Structural Engineering and Vibration Analysis
- Concrete and Cement Materials Research
- Fatigue and fracture mechanics
- Non-Destructive Testing Techniques
- Computational Geometry and Mesh Generation
- Mechanical stress and fatigue analysis
- Electronic Packaging and Soldering Technologies
- MXene and MAX Phase Materials
- Advanced Multi-Objective Optimization Algorithms
- Recycling and utilization of industrial and municipal waste in materials production
- Advanced Numerical Analysis Techniques
- Structural Health Monitoring Techniques
- Structural Response to Dynamic Loads
China Railway Group (China)
2025
China Railway 18th Bureau Group Corporation
2025
China University of Mining and Technology
2024
Tongji University
2019-2023
China University of Petroleum, East China
2019-2023
Kyoto Architecture University
2023
Kyoto University
2023
Central South University
2022
Guiyang University
2017
China Iron and Steel Research Institute Group
2016
In this research, the spodumene mining residue was used as siliceous material, completely replacing quartz sand, to prepare aerated concrete. The mechanical properties, pore structure, hydration characteristics of concrete, and residue–cement paste interaction mechanism were studied by orthogonal experiment, X-ray diffraction, Fourier-Transform Infrared Spectroscopy, thermogravimetry, mercury-injection test methods. result showed that water–cement ratio significantly affected properties dry...
Single-layer reticulated shells (SLRSs) are highly sensitive to initial geometric imperfections (IGIs) with respect their nonlinear buckling behavior. However, the traditional random imperfection modal method assumes joint deviations be independent, which leads member length always exceeding manufacturing error limit given by design codes, i.e., IGIs unrealistic, and load must inaccurate. This paper proposes a simple efficient generate stochastic for SLRSs considering topology constraints....
First Name is required invalid characters Last Email Address Invalid
Continuous cast AA 5083 aluminium alloy hot band with and without prior heat treatment at 510°C for 3 h was cold rolled to a reduction of 70% annealed 399°C h. It found that the showed strong {113}〈110〉 texture component after thermal mechanical treatment, while its recrystallisation almost random. The exhibited fine equiaxed grain structure annealing, in contrast coarse elongated one treatment. tensile properties their isotropy were greatly improved by concurrent precipitation effect likely...
Abstract Ultrasonic impact treatment (UIT) is a new surface strengthening method to reduce the residual stresses on large pressure vessels induced by and repair welding. An accurate high efficiency calculation model key accurately predicting full‐field under UIT process. In this article, full‐coverage impacting proposed simulate process of pin. The effects welded were investigated explicit dynamic simulation. Experiments also performed verify prediction results. Results show that full...
Extended abstract of a paper presented at Microscopy and Microanalysis 2009 in Richmond, Virginia, USA, July 26 – 30,