A5079913769- Thermodynamic and Exergetic Analyses of Power and Cooling Systems
- Aluminum Alloys Composites Properties
- Solar Thermal and Photovoltaic Systems
- Advanced Thermodynamics and Statistical Mechanics
- Microstructure and mechanical properties
- Metallurgy and Material Forming
- Welding Techniques and Residual Stresses
- Aluminum Alloy Microstructure Properties
- Railway Systems and Materials Science
- Advanced Welding Techniques Analysis
- Carbon Dioxide Capture Technologies
- Metal Forming Simulation Techniques
- Advanced Machining and Optimization Techniques
- Phase Change Materials Research
- Advanced machining processes and optimization
- Metal Alloys Wear and Properties
- Heat Transfer and Optimization
- Powder Metallurgy Techniques and Materials
- Advanced Surface Polishing Techniques
- Magnesium Alloys: Properties and Applications
- Heat Transfer Mechanisms
- Integrated Energy Systems Optimization
- Additive Manufacturing Materials and Processes
- Bone Tissue Engineering Materials
- Metal and Thin Film Mechanics
GLA University
2019-2024
Sarala Birla University
2021
Central Forensic Science Laboratory
2021
KIIT University
2021
Wildlife Institute of India
2017
Machining of titanium alloy grade V (Ti6Al4V) is very difficult by conventional metal cutting process due to low thermal conductivity, ability retain strength at elevated temperature, tendency work harden. This may result in high heat the zone and generation stresses. Therefore, present research die-sinking electrical discharge machining used machine Ti6Al4v alloy. A non-dominated sorting genetic algorithm (NSGA II) coupled with rotary central composite design (RCCD) based on response...
Abstract Laser welding is used in critical component production when tight tolerances like minimal distortions and residual stresses are required. beam offers a lower heat input, smaller affected zone, stresses, minimum distortions, greater mechanical joint characteristics than conventional does. In order to simulate the laser process on SS316L plates, Gaussian source model was used. The developed simulated with volumetric APDL coding using ANSYS. thermal profiles at cross sections via...
AA5083 with ultrafine grain structure was produced through equal channel angular pressing using different levels of ECAP tensions, underwent a series tensile tests. The superplasticity temperature 573 K at low temperatures. This study investigate how varying the strain influences distinctive microstructure alloy and its impact on deformation mechanisms within low-temperature range. A fraction high angle borders increased when from 1 to 2, while sub-grain size stayed nearly same. most...
In metal-cutting operations, the surface roughness of end product plays a significant role. It not only affects aesthetic appearance but also signifies product’s performance in long run. Products with high finish have higher endurance limits negligible local stresses. On other hand, products rough surfaces are subjected to stresses when they engaged various mechanical operations varying loads. Surface depends on machining factors such as feed rate, depth cut, cutting speed, or spindle speed....