A5025301596- Building Energy and Comfort Optimization
- Urban Heat Island Mitigation
- Solar Energy Systems and Technologies
- Wind and Air Flow Studies
- Solar Thermal and Photovoltaic Systems
- Thermal Radiation and Cooling Technologies
- Hygrothermal properties of building materials
- Energy Load and Power Forecasting
- Heat Transfer and Optimization
- Sustainable Building Design and Assessment
- Electric Power System Optimization
- Wind Energy Research and Development
- Radiative Heat Transfer Studies
- Geothermal Energy Systems and Applications
- Facilities and Workplace Management
- Greenhouse Technology and Climate Control
- Conservation Techniques and Studies
- Gas Dynamics and Kinetic Theory
- Heat Transfer and Boiling Studies
- Phase Change Materials Research
- Heat and Mass Transfer in Porous Media
- Refrigeration and Air Conditioning Technologies
- Thermography and Photoacoustic Techniques
- Electric Power Systems and Control
- Nanofluid Flow and Heat Transfer
Universidad Juárez Autónoma de Tabasco
2015-2023
Cultura
2016
Centro Nacional de Investigación y Desarrollo Tecnológico
2012-2014
This paper reports the application of RC dynamic models (network resistances and capacitances analogous to electrical networks) obtain heat loss coefficient (HLC) from a test campaign carried out in an in-use building. It is well-insulated building located Gainsborough, U.K. case study data were made available participants IEA–EBC Annex 71 project Building Energy Performance Assessment Based on In-Situ Measurements. The analysis reported this mainly focused identification main transfer...
This work studies the characteristics of wind resource for a location in north zone Tehuantepec isthmus. The study was conducted using climatic data from Cuauhtemotzin, Mexico, measured at different altitudes above ground level. allowed establishing profile speeds as well analysis its availability. Analysis results conclude that behavior speed presents bimodal distribution with dominant northeast direction (wind flow sea–land). In addition, area identified feasible use low power turbines. On...
Solar chimneys provide natural ventilation for buildings, reducing the energy consumption of mechanical systems. Therefore, analyzing losses through solar chimney components and inlet/outlet air channel is critical to develop a suitable design this passive system. In study, performance analysis single-channel (SC-SOCH) described; parametric study under laboratory conditions was conducted regarding gap (0.10, 0.15, 0.20 m) heat flux absorber plate (100, 200, 300, 400, 500 Wm −2 ). The were...
This work presents the design, construction, and evaluation of a rectangular ventilated cavity. The cavity has heated wall, fixed air inlet port, an outlet port that can change in four different configurations: C-1, gap is on upper side left wall; C-2, top C-3, middle C-4, right wall experimental tests were carried out with heating power 200 400 W. measured indoor temperatures nine points, surface temperatures, heat flows are reported for validation computer codes. Then, numerical modeling...
This work presents the design, construction, and instrumentation of a calorimeter with solar tracking to determine thermal optical properties monolithic glass samples 15 cm × maximum thickness 6 mm. The was designed considering an abstract methodology, where materials, for each its components, were selected from evaluation criteria functionality. prototype constructed instrumented quantify heat losses through walls. calibrated obtain uncertainty flows, gains system. results calibration...