A5103265117- Structural Behavior of Reinforced Concrete
- Building Energy and Comfort Optimization
- Innovative concrete reinforcement materials
- Concrete Corrosion and Durability
- Concrete and Cement Materials Research
- Building materials and conservation
- Solar Energy Systems and Technologies
- Phase Change Materials Research
- Solar Thermal and Photovoltaic Systems
- Urban Heat Island Mitigation
- Structural Load-Bearing Analysis
- Masonry and Concrete Structural Analysis
- Energy Load and Power Forecasting
- Arctic and Antarctic ice dynamics
- Greenhouse Technology and Climate Control
- Educational Environments and Student Outcomes
- Concrete Properties and Behavior
- Structural Engineering and Vibration Analysis
- Medical Research and Treatments
- Structural Response to Dynamic Loads
- Hygrothermal properties of building materials
- Air Quality Monitoring and Forecasting
- Adsorption and Cooling Systems
China Railway Group (China)
2022-2024
Chongqing Jiaotong University
2019-2024
Dalian University of Technology
2013-2019
Shenyang Jianzhu University
2013
First Institute of Oceanography
1991
Ultrahigh‐performance fiber‐reinforced concrete (UHPFRC) is an innovative material in the field of bridge engineering. With superior mechanical characteristics, this new reduced structural self‐weight and extended span modern bridges. A series tests should be conducted to establish reliable design rules for UHPFRC structures. This paper aimed at determining compressive behavior thin‐walled arch section a comparison was made with normal (NC) arch. Eighteen axial compression columns arches...
This research aims to investigate the efficiency of strengthening plain concrete (PLC) arches using UHPC. Thirteen segment arch models reinforced normal (NC, group N ) or ultra‐high performance (UHPC, U were tested in this study. The failure mode, strain distribution, and calculation bearing capacity PLC bridges with UHPC circle analyzed. experimental results showed that technology chiseling planting bars could provide sufficient bond strength on interface between reinforcement layer NC...
The indoor thermal environment of the traditional Kang building is poor. different zones differ quite a bit in heat supply. Thus, heating methods applied to are also different. and biomass fuel mass, which were applicable zones, studied. dynamic load was calculated provide basis for analysis. results showed that cannot meet demand severe cold most. transformation method can reduce auxiliary supply by 90% compared with Kang. determined. analysis not only ensure comfort, but avoid energy waste...
This paper performed compressive tests on corroded reinforced concrete (RC) columns with externally confined ultra-high performance (UHPC) jacket. The studied parameters in this testing program was the corrosion ratio of specimens. influences parameter behavior by UHPC jacket reported and discussed. test results revealed that when rust rate less than 20%, axial cracking typical failure mode unreinforced specimens, cracks rusted area gradually increased increase rate. When reached 30%,...
In recent years, thermal energy storage by means of phase change materials (PCMs) achieved considerable attention.This paper presented a new heat exchanger composite shape-stabilize material PEG/EG/SiO2. This can be applied to solar low temperature or indoor heating, which could make good use electric power cost between peak and valley. The effect inlet velocity temperatures in the ex-changer during charging discharging process has been simulated CFD modelling. According contrast analysis...