A5101977443- Electronic and Structural Properties of Oxides
- Diamond and Carbon-based Materials Research
- Metal and Thin Film Mechanics
- Advanced Surface Polishing Techniques
- Ferroelectric and Piezoelectric Materials
- Iterative Learning Control Systems
- Coal and Its By-products
- Graphene research and applications
- Metal Extraction and Bioleaching
- Advanced Measurement and Detection Methods
- Perovskite Materials and Applications
- Semiconductor materials and devices
- Soil, Finite Element Methods
- Metallurgical Processes and Thermodynamics
- Advancements in Photolithography Techniques
- MXene and MAX Phase Materials
- Analytical chemistry methods development
- Geotechnical Engineering and Underground Structures
- Surface Roughness and Optical Measurements
- Polymer Foaming and Composites
- Corrosion Behavior and Inhibition
- Radiation Effects in Electronics
- Polydiacetylene-based materials and applications
- Laser Material Processing Techniques
- 2D Materials and Applications
State Key Laboratory of Optoelectronic Materials and Technology
2024
Sun Yat-sen University
2024
University of North Texas
2023
Xi'an Technological University
2010-2020
Shaanxi Normal University
2018
The University of Sydney
2005
Xi'an University of Technology
2005
Using a scanning electron microscope, we irradiate graphene drums with electrons at an energy of 20 keV and dosage about 1.58 × 1017 electrons/cm2. The consist exfoliated in ambient air over holes having diameter 4.6 μm etched into SiO2 substrate. After irradiation, observe that the drum’s suspended monolayer (ML) region has ratio Raman D peak height, ID, to G IG, as high 6.3. In contrast, supported ML on substrate ID/IG 0.49. Previous studies have shown containing can leak vacuum low rate....
Abstract In this paper, the instability mechanism of Fe-Al inhibition layer produced by interfacial reaction in Al-containing zinc melts on hydrogen-reduced steel is studied detail. The results show that surface morphology hot-rolled at different temperatures mainly divided into porous and dense states. Due to activity after hydrogen reduction, degree galvanized interface also significantly different. When Al content 0.2 wt%, no detected interface. After that, influence was explored....
LaTiO 3 films were prepared under various deposition temperatures using electron beam evaporation on Si and fused quartz substrates. The relationship between the temperature structure properties of optics was investigated by XPS, XRD, optical testing. results showed that film is amorphous when below 200°C. refractive index increases from 1.8302 to 1.9112 at 1064 nm with rise temperature. extinction coefficient less than 10 −6 in range 350 1700 nm. laser damage threshold first then decreases...
Quality of exposures in step and scan lithographic equipment highly depends on the synchronization wafer reticle stage. In order to increase between two stages, a high precision control method for scanning movement stage based phase compensation tracking error with same frequency is presented. This quite different from traditional ones, which just focus designing systems this paper, analysis relationship MA, MSD correlation errors, estimation frequency, performance improved notably. Compared...
Abstract In order to obtain the relationship between properties and oxygen flow rate of La 2 Ti O 7−x film, films were prepared by electron beam evaporation with various rates on Si quartz substrates. The effects film analyzed XRD, XPS, optical constant laser damage test. result shows that lose lead transition 4+ 3+ in oxygen-free environment. When is greater than 4 sccm, content stable. refractive index decreases increase stabilizes at sccm. extinction coefficient deposited environment less...