A5049515822- Coal Combustion and Slurry Processing
- Power Systems and Renewable Energy
- Thermochemical Biomass Conversion Processes
- Radiative Heat Transfer Studies
- Thermodynamic and Exergetic Analyses of Power and Cooling Systems
- Catalytic Processes in Materials Science
- Advanced Algorithms and Applications
- Coal and Coke Industries Research
- Dynamics and Control of Mechanical Systems
- Advanced Battery Technologies Research
- Coal Properties and Utilization
- Aerodynamics and Acoustics in Jet Flows
- Fluid Dynamics and Turbulent Flows
- Structural Analysis and Optimization
- Vibration and Dynamic Analysis
- Wound Healing and Treatments
- Textile materials and evaluations
- Environmental Changes in China
- Geoscience and Mining Technology
- Silk-based biomaterials and applications
- Collagen: Extraction and Characterization
- Extenics and Innovation Methods
- Environmental and Agricultural Sciences
- Coal and Its By-products
- Grey System Theory Applications
Chinese PLA General Hospital
2024
Chinese Academy of Geological Sciences
2013
In this paper, the leakage flow in blade tip clearance of an axial fan is studied, and improved strategy for increasing chord length toward inflow direction proposed. It has been proved that extending can move backward. This results attenuation vortex intensity a mitigation losses. Through comparative unsteady simulations, it observed reduction amplitude pressure pulsations surrounding trailing edge leads to corresponding decrease noise source. The experiment show that, under target...
Micro/nano drug delivery systems can provide ideal controlled release. Microfluidic chip technology plays an important role in the preparation of microspheres. Sodium alginate (SA) has been used to prepare microspheres as carriers owing its good biosafety and easy preparation. However, these lack antimicrobial activity loading efficiency, which prevent their application for infected wound repair. Although silver nanoparticles (AgNPs) possess broad-spectrum antibiotic activity, liquid...
Abstract The coal quality characteristics of urban sludge were analyzed, and three types coal-sludge-coupled power generation technologies introduced, including direct mixing, flue gas drying steam indirect coupling generation. Three in coal-fired plant blending process, after directly by indirectly steam. control values ratio moisture content are it is considered that the should be controlled within 5%. at 30-40% 10%. influence on operation unit analyzed. boiler stable, fly ash slag has...
The method and procedure of ammonia injection optimization test in SCR denitrification unit thermal power plant are introduced.The a 220MW is investigated, through test, the distribution uniformity NOx at outlet improved, escape concentration reduced, then damage to boiler tail equipment economic reliability improved.
Abstract Taking the flue gas recirculation system of 220MW coal-fired unit as test object, effects operation mode on operating characteristics boiler under different working conditions was studied. The results show: To a certain extent, will reduce efficiency, which is more obvious low load conditions. However, can effectively increase temperatures reheat steam and superheated steam.Comparing economics front rear units recycling system, it be find that net coal consumption 200MW 140MW...
In this paper, combined with experiments and theoretical calculations, the effect of urban low-calorific value sludge on slagging characteristics easy-slagging coals is studied. The results show that when melting point ash lower than coal ash, mixture after two blends will be raw ash. When SiO 2 Al O 3 , which are relatively high in sludge, used as single additives, first decrease then increase. As mixing ratio increases, a trend gradual relief. For prone to rich alkali metals, they can...
The large flexible solar array for the satellite will deploy when it reaches scheduled orbit by space rocket, which is key normal running of satellite. However, undesirable and unpredicted frequency vibration may be resulted from flexibility elements array. In this paper, dynamic model panel was firstly developed based on modal synthesis method. Moreover, stretchable mechanism in introduced applying Euler-Bounerlli beam theory. Also, guide ropes, hinges electric cables were considered...
Abstract In this paper, the peaking capacity test is carried out for 330MW unit to compare peak shaving performance of under extraction state. The content divided into three parts, respectively (a) operating at minimum output pure condensing condition, (b) load with maximum steam condition and (c) electric condition. It can be seen from results that electrical 3 conditions 128.4 MW, 128.6 124.8 respectively. Under industrial about 40t/h, has almost no change, compared
Abstract In this paper, the operation characteristics of a 480t/h ultra-high pressure pulverized coal fired boiler with municipal sludge were studied. The results show that: mixing has negative impact on thermal efficiency operation, and decrease evaporation increase ratio, decline increases, but can effectively reduce emissions nitrogen oxides sulfur dioxide in boiler. Through optimization adjustment test, it is found that optimal oxygen content 3.61% when proportion 5%.