A5059732884- Hydrogen Storage and Materials
- Ammonia Synthesis and Nitrogen Reduction
- Magnesium Alloys: Properties and Applications
- Nuclear Materials and Properties
- Rare-earth and actinide compounds
- Hydrogen embrittlement and corrosion behaviors in metals
- Magnetic Properties of Alloys
- MXene and MAX Phase Materials
- Gas Sensing Nanomaterials and Sensors
- Hybrid Renewable Energy Systems
- Aluminum Alloys Composites Properties
- Corrosion Behavior and Inhibition
- Non-Destructive Testing Techniques
- Fusion materials and technologies
- ZnO doping and properties
- Iron-based superconductors research
- Advancements in Battery Materials
- Crystallography and Radiation Phenomena
- Force Microscopy Techniques and Applications
- Intermetallics and Advanced Alloy Properties
- High Temperature Alloys and Creep
- Metallurgical and Alloy Processes
- Muon and positron interactions and applications
- Crystallization and Solubility Studies
- Magnetic Properties and Applications
National Institute of Advanced Industrial Science and Technology
2013-2024
Anhui University
2007
National Institute for Materials Science
1998-2002
Tohoku University
1987-2002
Industrial Research Institute
1999
ZnO-SnO2 thin films are deposited by rf sputtering using a sintered oxide target. As-deposited show different crystal structures of hexagonal ZnO, spinel type intermediate compound Zn2SnO4 or an amorphous experimental conditions. The higher than 80% transmissivity over the visible range and their lower side absorption edge is less 320 nm. electrical resistivity as sputtered about 5.0 × 10−2 Ω cm decreased up to 1.7 vacuum annealing due rapid increase both, oxygen vacancies carrier...
An energy-domain 57Fe-Mössbauer spectrometer using synchrotron radiation (SR) with a diamond anvil cell (DAC) has been developed for ultrahigh-pressure measurements. The main optical system consists of single-line pure nuclear Bragg reflection from an oscillating 57FeBO3 single crystal near the Néel temperature and X-ray focusing device. can filter Doppler-shifted narrow bandwidth neV order broadband SR source. focused incident X-rays make it easy to measure small specimen in DAC. present...
The effect of Li addition to Mg on synthesis Mg-Ti BCC alloys by means ball milling was studied. Mg–x at%Li (x=4,20,46) prepared the induction melting method consisted HCP phase (Mg-type), + (Li-type) and phase, respectively. Lattice parameters decreased with increase in x, whereas those at x=20 46 were smaller than that Li. Ti milled for 50–200 h an argon atmosphere. Formation Mg96Li4Ti100 alloy confirmed X-ray diffraction (XRD) measurements after 50 milling. By Mg, time shortened. made...