A5020707027- Thermochemical Biomass Conversion Processes
- Electrocatalysts for Energy Conversion
- Electrical Fault Detection and Protection
- HVDC Systems and Fault Protection
- Advancements in Battery Materials
- Advanced battery technologies research
- Fuel Cells and Related Materials
- Subcritical and Supercritical Water Processes
- High-Voltage Power Transmission Systems
- Catalysts for Methane Reforming
- Advanced Battery Materials and Technologies
- Thermal and Kinetic Analysis
- Silicon Carbide Semiconductor Technologies
- Vacuum and Plasma Arcs
- Catalysis and Oxidation Reactions
- Catalytic Processes in Materials Science
- MXene and MAX Phase Materials
- Combustion and Detonation Processes
- Heat transfer and supercritical fluids
- TiO2 Photocatalysis and Solar Cells
- Copper-based nanomaterials and applications
- Coal Combustion and Slurry Processing
- Advanced Memory and Neural Computing
- Flow Measurement and Analysis
- Combustion and flame dynamics
Xi'an University of Technology
2024
Xi'an Jiaotong University
2007-2023
Harbin Institute of Technology
2011-2022
Shenzhen Institute of Information Technology
2021-2022
Printed Electronics (United Kingdom)
2021
Xi’an University of Posts and Telecommunications
2021
Chalmers University of Technology
2015-2017
Huazhong University of Science and Technology
2013-2016
State Council of the People's Republic of China
2016
Technical University of Denmark
2011-2012
Biomass gasification and pyrolysis were studied in a laboratory-scale atmospheric pressure entrained flow reactor. Effects of operating parameters biomass types on the syngas composition investigated. In general, carbon conversion during was higher than 90% at optimal conditions 1400 °C with steam addition. The that not converted to gas process only appeared as soot particles all experiments, except for two experiments performed 1000 °C, where very small amount char also left. comparison...
CoFe@HNSs exhibited bifunctional oxygen electrocatalytic activity, and exhibit a high-power density of 131.3 mW cm<sup>−2</sup> long-term stability over 140 h.
Biomass gasification experiments were carried out in a bench scale entrained flow reactor, and the produced solid particles collected by cyclone metal filter for subsequent characterization. During wood gasification, major part of material is soot. Scanning electron microscopy (SEM) images coupled with energy dispersive spectroscopy (EDS) show agglomerated nanosize spherical soot (<100 nm) that are very rich carbon. In comparison to content sample from straw quite low, while contents KCl...
Through the accurate calculation of density functional theory, reveal excellent photoelectric properties AlN/WSSe and WSSe/AlN heterojunction. Especially, hole mobility heterojunction is as high 3919 cm
The drawn vacuum arc begins with a bridge column formed from the explosion of liquid metal after separating contacts. expansion process initial has an effect on motion or diffusion. In order to deeply study influence transverse magnetic field (TMF) and axial (AMF) characteristics in stage, this article, ignition mode appearance under two groups contacts different AMF TMF components were experimentally studied. It was found that simultaneously reducing would end stage earlier, fluctuation...
We report the formation and characterization of Cu<sub>2</sub>O/TiO<sub>2</sub> nanotube-array coaxial heterogeneous structure, which is supposed to have potential applications in photo-induced water decomposition organic pollutant degradation.
Abstract In order to ensure the reliable interruption of high voltage direct current circuit breaker (HVDC CB), breaking test HVDC CB plays an important role in its performance verification. this paper, process is analyzed, and equivalent requirements for are summarized. current, transient (TIV) duration short, which leads insufficient stress. A new synthetic testing CBs proposed, can solve problem TIV caused by capacity. Subsequently, working principle introduced detail design method...
Abstract Development towards HVDC grids is drawing intense development of circuit‐breakers (CBs). The increasing rated voltage and capacity requires CBs with excellent performance to be installed comprehensive tests on are indispensable. This paper contributes clarifying clearer test requirements the current interruption test, which most challenging one proposing a novel applicable method. It toughest because when an CB interrupts fault current, high transient (TIV) produced by operation...
Abstract Developing efficient, economical, and durable transition metal atom‐dispersed catalysts to boost the sluggish oxygen reduction reactions (ORRs) is crucial for practical metal‐air batteries. Herein, a facile dopamine‐coordination strategy was developed obtain tangled Fe, N co‐doped ultrathin carbon nanosheets (donated as Fe−N−C nanosheets), which can be utilized high‐performance ORR electrocatalysts. Benefited from unique hierarchical porous structures abundant Fe−N x active sites,...
China is an arid country, but leakthrough phenomenon widespread in chinese architecture, which resulting invalid water supply and the waste of resource. The structure this device simple effect obvious.Its working principle to use pressure difference between waterproof plugs store a certain big amount flow by accumulating small can not be measured,.Making micro-flow discontinuous high measured water-flowmeter,so as achieve accurate measurement micro-flow. In addition, precise losses head are...