A5031553339- Recycled Aggregate Concrete Performance
- BIM and Construction Integration
- Construction Project Management and Performance
- Sustainable Supply Chain Management
- Municipal Solid Waste Management
- Advanced Manufacturing and Logistics Optimization
- VLSI and FPGA Design Techniques
- Healthcare and Environmental Waste Management
- Value Engineering and Management
- Embedded Systems Design Techniques
- Scientific Measurement and Uncertainty Evaluation
- Geotechnical and construction materials studies
- Architecture and Cultural Influences
- Silicon Carbide Semiconductor Technologies
- Multilevel Inverters and Converters
- Sustainable Development and Environmental Policy
- Facilities and Workplace Management
- High voltage insulation and dielectric phenomena
- Quantum-Dot Cellular Automata
- Advanced Sensor Technologies Research
- Sensor Technology and Measurement Systems
- Low-power high-performance VLSI design
- Electromagnetic Compatibility and Noise Suppression
- Architectural and Urban Studies
Defence Research and Development Laboratory
2022
Universiti Teknologi MARA
2013-2021
The University of Queensland
2016-2019
Environmental Earth Sciences
2017-2019
Jawaharlal Nehru Technological University, Hyderabad
2018
The aim of this paper is to reduce the Common Mode Voltage (CMV) in Diode Clamped Multilevel Inverter (DCMLI). Three phase star connected RL load DCMLI. common mode voltage exists between point & system ground. Premature failure bearings Induction Motor (IM) caused by CMV and necessary reduce. In paper, Phase Disposition Sinusoidal Pulse Width Modulation (PD SPWM) technique used for reduction LC filter Harmonics. MATLAB Simulink simulation circuit. Total Harmonic Distortion (THD) are investigated.
In the Design and Build (DB to establish integrated elements (social technical) for D&B projects. Empirical research was undertaken based on six case studies public private projects in Malaysia. The findings suggest that value management constructability are viable be implemented technically whilst, partnering promotes quality of life among project participants. Finally, a conceptual framework an process improvement solution is proposed deliver best
In recent years, Malaysia has faced an intense demand for infrastructure development and the construction industry become integral part of transforming country into a developed nation. Large numbers works are perturbing they subject to improper management demolition (C&D) wastes. Lacking in methods managing C&D wastes throughout cycle jeopardized effort preserve environment. Circular economy (CE) was used as basis improve waste system Malaysia. We have circularity-based planning...
In aerospace applications static tests are carried out for design qualification and validation. During different types of parameters measured acquired. Performance analysis the system under test is using acquired data. Pressure a very important parameter used performance such related systems subsystems. transducers measuring pressure parameter. available with cavity or without cavity. Based on type transducer response varies same modeled differently. This paper presents Helmholtz resonator...
In recent decades, the construction industry has been widely criticized for its lack of efficiency and productivity, it shown that Malaysian records poor quality on projects. To overcome this issue, Technical Committee Quality Assessment in Construction with support Industry Development Board (CIDB) introduced System (QLASSIC). QLASSIC is a scoring system used to assess evaluate performance buildings. It based Standard (CIS 7:2006). Unfortunately, assessment had implementation since...