A5035013964- X-ray Spectroscopy and Fluorescence Analysis
- Laser-induced spectroscopy and plasma
- Corrosion Behavior and Inhibition
- Atomic and Molecular Physics
- Industrial Vision Systems and Defect Detection
- Aluminum Alloys Composites Properties
- Non-Destructive Testing Techniques
- Advanced Fiber Optic Sensors
- Magnesium Alloys: Properties and Applications
- Total Knee Arthroplasty Outcomes
- Grouting, Rheology, and Soil Mechanics
- Railway Engineering and Dynamics
- Soil Mechanics and Vehicle Dynamics
- Geotechnical Engineering and Soil Stabilization
- Orthopedic Infections and Treatments
- Landfill Environmental Impact Studies
- Photonic Crystal and Fiber Optics
- Remote Sensing and Land Use
- Advanced Decision-Making Techniques
- Advanced Fiber Laser Technologies
- Mechanical Engineering and Vibrations Research
- Advanced Algorithms and Applications
- Photonic and Optical Devices
- Orthopaedic implants and arthroplasty
- Vehicle Dynamics and Control Systems
Jilin University
1999-2025
University of Science and Technology Beijing
2023
Crystal structure prediction (CSP) is a foundational computational technique for determining the atomic arrangements of crystalline materials, especially under high-pressure conditions. While CSP plays critical role in materials science, traditional approaches often encounter significant challenges related to efficiency and scalability, particularly when applied complex systems. Recent advances machine learning (ML) have shown tremendous promise addressing these limitations, enabling rapid...
Radiative lifetimes of 79 levels belonging to the 3d34s4p, 3d44p, 3d34s5p, 3d45p, and 3d34s4d configurations V i with energy from 26,604.807 46,862.786 cm−1 have been measured using time-resolved laser-induced fluorescence (TR-LIF) spectroscopy in laser-produced plasma. The lifetime values reported this paper are range 3.3–494 ns, uncertainties these measurements within ±10%. A good agreement was obtained previous data. HFR+CPOL calculations performed used combine calculated branching...
Abstract The effect of corrosion on the tensile behavior an as‐cast AZ91 alloy was investigated via systematical experiments. residual strength magnesium is approximately negative linear dependent extreme depth pit, which quantitatively obtained by morphology analysis and statistic analysis. Experimental results reveal that dropped quickly in first 40 h due to initiation development pit subsequently decreased slowly as a result encountered β phase. phase at grain boundary primary α acts...
A method for accurately adjusting the chirp parameter of fabricated chirped fibre Bragg gratings (CFBGs) is demonstrated experimentally. By establishing different strain gradients with proper profile along length CFBGs, one can not only increase or decrease CFBG, but also change sign without exchanging two ends grating. The variance chirp's amplitude be tuned through varying gradient. Moreover, grating's reflectivity hardly decreases and shape reflection spectrum stays good during...