A5103537072- Advancements in Battery Materials
- Carbon Nanotubes in Composites
- MXene and MAX Phase Materials
- Advanced battery technologies research
- Nanofluid Flow and Heat Transfer
- Petroleum Processing and Analysis
- Conducting polymers and applications
- Semiconductor materials and interfaces
- Nanomaterials for catalytic reactions
- Polymer-Based Agricultural Enhancements
- Electric Power System Optimization
- Ammonia Synthesis and Nitrogen Reduction
- Organic Light-Emitting Diodes Research
- Smart Materials for Construction
- Plant Gene Expression Analysis
- Plant Growth Enhancement Techniques
- Transition Metal Oxide Nanomaterials
- Biosensors and Analytical Detection
- Organic Electronics and Photovoltaics
- Pharmaceutical and Antibiotic Environmental Impacts
- Fullerene Chemistry and Applications
- Chemical and Physical Properties of Materials
- Molecular Junctions and Nanostructures
- Tea Polyphenols and Effects
- Phytochemistry and Bioactivity Studies
Changchun University of Science and Technology
2023-2024
Panzhihua University
2024
Sichuan University of Science and Engineering
2024
Changjiang Water Resources Commission
2023
Zhejiang Sci-Tech University
2021
Tianjin Research Institute of Electric Science (China)
2020
Harbin Institute of Technology
2020
North China Electric Power University
2019
Sichuan University
2012-2017
National Taiwan Normal University
2008-2014
Abstract Eutectic metal particles and carbon nanotubes are incorporated into a thermoplastic polyurethane matrix through simple but efficient method, melt compounding, to tune the resistivity–strain behavior of conductive polymer composite (CPC) fibers. Such combination fillers is rarely used for CPCs in literature. To characterize strain‐sensing properties these fibers, both linear dynamic strain loadings carried out. It noted that higher content fibers results sensitivity. These discussed...
The 0.5 wt.% multiwalled carbon nanotubes/water nanofluids (MWNFs) were produced by using a two‐step synthetic method with different types and concentrations of stabilizers. static position method, centrifugal sedimentation zeta potential measurements, rheological experiments used to assess the stability MWNFs determine optimal type fixed MWCNTs‐stabilizer concentration stabilizer. Finally, MWCNTs ratio stabilizer, their stability, thermal conductivity, pH measured feasibility them in heat...
A revised water‐assisted synthesis system (RWAS) was used to fabricate carbon/water nanofluids (CWNFs). The CWNFs were manufactured by heating graphite rods at different temperatures (700, 800, 900, and 1000°C). Aspects of the suspended nanocarbon, such as morphology, structure, optical characteristics, production rate, fully characterized. Furthermore, suspension performance controlled adding a dispersant (water‐soluble chitosan) concentrations. Finally, determined assess influence both...
What China committed in the Paris Agreement encourages penetration of renewable energy power grid. To consume more energy, coal-fired units undertake most part peak shaving task and are usually operated at a low-load level during off-peak hours. However, deep has harmed benefits thermal plants also brought about environmental problems. improve peak-shaving capacity operation efficiency units, government flexibility retrofits for units. In this paper, related cost functions proposed...
Wearable solar radiation sensors based on ionic hydrogels are facilely prepared to simultaneously monitor the dose for production of vitamin D and prevention sunburn. Tetramethylethylenediamine (TEMED) is neutralized with acrylic acid (AA) obtain tetramethylethylenediamine acrylate (TEMEDA), which further polymerized acrylamide by a free radical reaction. By simply adding MB or NR during polymerization, final obtained can indicate radiation. Due extent discoloration, discoloration speed...
Abstract The sulfate reducing bacteria(SRB) is commonly attached to the surface of buried pipeline steel, and electron shuttle in corrosion medium can promote release electrons from iron oxidation through bacterial cell wall into cytoplasm accelerate anode iron. This study investigated impact riboflavin (RF) as an endogenous on behavior X80 steel SRB system. findings indicated that while type products remains unchanged samples under SRB+10 mg l −1 RF system, there was expansion both area...
Download This Paper Open PDF in Browser Add to My Library Share: Permalink Using these links will ensure access this page indefinitely Copy URL DOI
Abstract:
Abstract A series of five new conjugated polythiophene (PT) derivatives containing piperidinyl groups as a side chain were synthesized by ferric trichloride oxidization. All the polymers soluble in common organic solvents, and their high regioregularity confirmed 1 H‐NMR. The weight‐average molar masses ranged from 5931 to 22,955 g/mol with low polydispersity index ranging 1.18 1.79. fluorescence emission maximum poly[3‐( N ‐methyl propionate–4′‐piperidine)methylene–thiophene] films was 725...
Emerging lithium metal batteries are one of the candidates for increasing energy density beyond that traditional lithium-ion batteries. Whereas, intrinsic dendrites growth is a chronic disease severely hampered application Hence, partial alloying electrode (LiAl and LiC alloy) with lithiophilic sites interconnected ion-electron conductive skeleton presented through repeated folding-rolling strategy. Electrochemical measurement in situ optical microscopy demonstrate effectiveness anode...