Jingliang Wang

ORCID: 0009-0007-8553-5096
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • Granular flow and fluidized beds
  • Advancements in Battery Materials
  • Advanced Battery Materials and Technologies
  • Thermochemical Biomass Conversion Processes
  • Particle Dynamics in Fluid Flows
  • Cyclone Separators and Fluid Dynamics
  • Microwave Engineering and Waveguides
  • Optical measurement and interference techniques
  • Educational Technology and Pedagogy
  • Antenna Design and Analysis
  • Molten salt chemistry and electrochemical processes
  • Supercapacitor Materials and Fabrication
  • Advanced Vision and Imaging
  • Heat and Mass Transfer in Porous Media
  • Metallurgical Processes and Thermodynamics
  • High-Voltage Power Transmission Systems
  • Agricultural Engineering and Mechanization
  • Advanced Antenna and Metasurface Technologies
  • Advanced Optical Sensing Technologies
  • Software-Defined Networks and 5G
  • Concrete Corrosion and Durability
  • Structural Engineering and Vibration Analysis
  • ECG Monitoring and Analysis
  • Structural Health Monitoring Techniques
  • Radio Frequency Integrated Circuit Design

China Iron and Steel Research Institute Group
2024

Huazhong University of Science and Technology
2024

North China University of Technology
2023-2024

Jiangsu Maritime Institute
2020-2023

Hunan Provincial Science and Technology Department
2022-2023

Wuhan University of Technology
2020-2023

Hefei University of Technology
2022

Xinjiang University
2021

Yunnan Normal University
2015

University of Shanghai for Science and Technology
2014

Biomass straw fuel has the advantage of low-carbon sustainability, and therefore, it been widely used in recent years coupled blending combustion with coal-fired utility boilers for power generation. At present, drag force FD, lift FL, torque T evaluation model are very limited. In this study, within a wide range Reynolds numbers (10 ≤ Re 2000) incident angles (0° θ 90°), computational fluid dynamics open source code OpenFOAM-body-fitted mesh method is to carry out direct numerical...

10.1063/5.0186621 article EN Physics of Fluids 2024-01-01

This study investigates the convective heat transfer characteristics of disk-shaped biomass particles, a critical factor for particle heating and conversion in co-firing boilers that has been underexplored literature. Using particle-resolved direct numerical simulation (PR-DNS), we analyze behavior cold fluid flowing over heated disk focusing on effects aspect ratio or height-to-diameter (Ar), Reynolds number (Re), incidence angle (θ) average Nusselt (Nu). The results reveal efficiency is...

10.1063/5.0253524 article EN Physics of Fluids 2025-02-01

In numerical simulations of biomass co-firing in coal-fired power plant boilers, the current literature lacks precise models for drag, lift, and torque coefficients non-spherical particles. To address this gap, study develops a novel set aerodynamic coefficient correlations specifically disk-shaped particles across varying aspect ratios (0<Ar < 1), Reynolds numbers (1≤Re ≤ 2000), angles attack (0°≤θ 90°). Using body-fitted mesh method OpenFOAM, combined with direct simulation...

10.1063/5.0253936 article EN Physics of Fluids 2025-03-01

Abstract With the widespread applications of electric vehicles, power grid stabilization, and high‐pulsed loads, high‐power lithium‐ion batteries (LIBs) are in urgent demand. However, existing experimental‐based design is usually costly inefficient, provides limited information on complex physicochemical processes inside batteries. Digital twin concept promising for capturing batteries’ electrochemical performance, optimizing capability LIBs. Here, an electrochemical‐thermal coupled model...

10.1002/aenm.202202660 article EN Advanced Energy Materials 2022-11-11

Due to their high reliability, anti-interference, and power capacity, metal waveguide slot array antennas are commonly used in harsh extreme working conditions. However, the fractional bandwidth of is usually not wide enough (<20%), which limits performance microwave system. Aiming at expanding bandwidth, this letter proposes a antenna utilizing hybrid resonant structures. Five resonance frequency points simultaneously excited subtly arranged, resulting great expansion band. The measured...

10.1109/lawp.2022.3228542 article EN IEEE Antennas and Wireless Propagation Letters 2022-12-12

The pyrolysis of pine sawdust was carried out in a fixed bed reactor heated from 30 °C to maximum 700 atmospheric nitrogen and pressurized hydrogen (5 MPa). yield, elemental composition, thermal stability, composition the two bio-oils were analyzed compared. result shows that oxygen content bio-oil (17.16%) obtained under atmosphere lower while heating value (31.40 MJ/kg) higher than those produced atmosphere. Compounds with boiling point less 200 account for 63.21% at atmosphere, proportion...

10.3390/app12010046 article EN cc-by Applied Sciences 2021-12-21

A novel vanadium pentoxide (V 2 O 5 ) nanoplatelet has been prepared by an oxalic acid assisted sol–gel method using β-cyclodextrin as exfoliation agent followed sintering at a high temperature. Crystal structure and morphology are analyzed X-ray diffraction (XRD) scanning electron microscopy (SEM), respectively. Due to about 10 nm thick, the product shows large chemical diffusion coefficient of Li + ions over -10 cm s -1 room In potential range 4.0–2.0 V (vs. Li/Li ), it can deliver initial...

10.1142/s1793604712500191 article EN Functional Materials Letters 2012-02-28

To reduce the area occupied by delay lines for 5G sub-6-GHz frequency band, a 3-D rolled-up structure is presented in this letter. According to rules proposed letter, conventional planar interdigital line rolled up, transforming initially device into spiral geometry. When rolling 1 turn, reduced over 65% while maintaining similar performance unrolled device. From 6 GHz, return loss of input and outputs port greater than 13.1 dB, insertion less 3 dB. The group 1.8 ns±5% operating band.

10.1109/lmwc.2022.3162774 article EN IEEE Microwave and Wireless Components Letters 2022-04-19

The escalating threats of climate change and fossil fuel depletion have greatly spurred the widespread utilization renewable energy sources. Biomass stands out as most abundant resource. Among all biomass conversion technologies, direct combustion for heating power generation represents common cost-effective approach. Suspended technology is widely employed in existing plants worldwide. However, conventional modeling procedures often fail to adequately address differences between coal...

10.56028/aetr.11.1.869.2024 article EN Advances in Engineering Technology Research 2024-08-20

Sensor calibration is an important step in SLAM, and lightweight, inexpensive sensors are often used Augmented Reality applications. The accuracy of sensor directly affects the reliability subsequent image processing, recognition, perception, positioning. inertial processing unit robust to sudden motion effect, blurring appears middle camera motion, overlap area between two frames too small, so it difficult match feature points. itself can solve problem IMU drift slow complementary. VI‐SLAM,...

10.1002/sdtp.17194 article EN SID Symposium Digest of Technical Papers 2024-04-01

For engineering structures, strain flexibility-based approaches have been widely used for structural health monitoring purposes with prominent advantages. However, the applicability and robustness of method need to be further improved. In this paper, a novel damage index based on differences in uniform load field (ULSF) is developed plate-like structures. When estimating ULSF, flexibility matrix (SFM) mass-normalized mode shapes (SMSs) needed. are complicated difficult obtain when input,...

10.3390/s20236862 article EN cc-by Sensors 2020-11-30

The camera calibration is a hot issue in the field of photogrammetry. A chessboard plane introduced to simplify difficulty calibration. In this paper, first, corners are detected by Harris. Then, geometrical relationships calculated between image and three-dimensional space. Finally, intrinsic external parameters calibrated based on model. Experimental results show that method effective.

10.1109/geoinformatics.2015.7378683 article EN 2015-06-01

Digital Twins In article number 2202660, Dongsheng Ren, Jingyi Qiu, Jingliang Wang, Xiangming He, Hao Zhang, and co-workers propose a digital twin-based approach for rational design of ultrahigh-power LiFePO4/graphite lithium-ion batteries. Model-driven optimization batteries is successfully realized, aiming at the critical factors in rate-determining steps. The battery shows high energy density 92.38 Wh kg−1 an ultrafast discharging current 50 C can withstand 150 pulse discharging.

10.1002/aenm.202370002 article EN Advanced Energy Materials 2023-01-01

At present, emotion recognition has become a research hotspot in the field of pattern recognition. Considering problems incomplete information and strong interference single‐modal recognition, multimodal been widely studied. Multimodal data includes, but is not limited to, emoji, text, voice modality data. There are various ways to express emotion, among which expression, text most direct reliable emotional carriers. Therefore, it great practical significance comprehensively consider...

10.1002/sdtp.16359 article EN SID Symposium Digest of Technical Papers 2023-04-01
Coming Soon ...