A5003585362- Solar-Powered Water Purification Methods
- Membrane Separation Technologies
- Membrane-based Ion Separation Techniques
- Solar Thermal and Photovoltaic Systems
- Reservoir Engineering and Simulation Methods
- Enhanced Oil Recovery Techniques
- Magnetic Properties and Synthesis of Ferrites
- Advanced Computational Techniques and Applications
- Hydrocarbon exploration and reservoir analysis
- Advancements in Battery Materials
- Electromagnetic wave absorption materials
- Hydraulic Fracturing and Reservoir Analysis
- Solar Energy Systems and Technologies
- Advanced Data Processing Techniques
- Advanced Battery Technologies Research
- Geothermal Energy Systems and Applications
- Adsorption and Cooling Systems
University of Miskolc
2023-2024
University of Jeddah
2019-2022
RMIT University
2019-2022
This research is investigating the possibility of using heat stored in solar ponds for salt drying. At present, Pyramid Salts, a producing company located north Victoria, Australia, use electric heaters to ambient air from around 20 °C 70 their crystallizers paper aims develop PV driven pump coupled with pond supply necessary hot air. According collected data performance Hill indicates that will be available at bottom between 35 50 (winter summer). Coupling salinity gradient novelty this...
Abstract This paper presents an experimental investigation of heat transfer in direct contact membrane distillation (DCMD) flow channels with and without the spacer. In this experiment, usual hydrophobic DCMD is replaced by a copper plate to eliminate mass transfer. The study shows most appropriate correlations for empty channel cases different heights rates. For case spacer channels, two materials are investigated: nonwoven plastic woven stainless steel. correlation both these materials....
This paper describes the experimental method to establish a salinity gradient in MgCl2 solar pond (SGSP) at Bundoora East campus of Royal Melbourne Information Technology (RMIT) University, Melbourne, Australia. The was instructed 2001, with 15 m2 surface area. experiment involves using saturated brine lower thermal storage (or convective) zone (LCZ) as well middle insulating layer which decreases height. non-convective (NCZ) is proctored from mixings caused by wind and destabilizing effects...
This paper describes the practical experience gained from setting up salinity gradient in a MgCl solar pond at Bundoora East campus of Royal Melbourne Institute Technology (RMIT) University, Melbourne, Australia. involves using saturated brine to establish lower thermal storage (or convective) zone (LCZ) as well middle insulating layer which decreases with height. non-convective (NCZ) is protected mixings caused by wind and destabilising effects diurnal variation ambient temperature an upper...
Membrane distillation (MD) is a thermally-driven separation technology that can produce highly pure water. Direct contact membrane (DCMD), where both hot and cold solution directly in with the hydrophobic most studied system due to its condensation method without an external condenser as well overall structural simplicity. In this paper, heat transfer analysis was carried out DCMD experimentally investigate how presence of spacer effect on coefficient. Results revealed coefficient for...
Abstract The estimation of a gas viscosity experimentally is often difficult. So, accurate determination has been the main challenge in reservoir development. There are many correlations to estimate this property. Often time, results these do not agree with experimental data, thereby causing considerable amount error. difficulty can be propagated simply by tuning against some data using artificial intelligent model. Currently, achievements neural networks (ANN) techniques alone predict open...
One of the primary responsibilities a reservoir engineer is to evaluate performance hydrocarbon reservoirs estimate original hydrocarbons in place, reserves, ultimate oil/gas recovery factor. This responsibility becomes complicated case water-drive due high uncertainty associated with aquifer properties, including rock properties and geometry. paper presents new method find optimum model based on root mean square error (RMSE) values by using MBAL software. The study investigated...
In the direct contact membrane distillation (DCMD) system, temperature polarization due to boundary layer formation limits system performance. This study presents experimental results and heat transfer analysis of a DCMD module coupled with salinity gradient solar pond (SGSP) under three different flow channel configurations. first case, feed permeate channels were both empty, while in next two cases, filled porous spacer material. Two geometries are examined: 1.5 mm thick filament angle...