A5050464787- Welding Techniques and Residual Stresses
- Hydrogen embrittlement and corrosion behaviors in metals
- Microstructure and Mechanical Properties of Steels
- Aluminum Alloy Microstructure Properties
- Advanced Welding Techniques Analysis
- High Temperature Alloys and Creep
- Aluminum Alloys Composites Properties
- Metal Alloys Wear and Properties
- Corrosion Behavior and Inhibition
- Intermetallics and Advanced Alloy Properties
- Advanced ceramic materials synthesis
- Additive Manufacturing Materials and Processes
- High Entropy Alloys Studies
- Metal and Thin Film Mechanics
- Fatigue and fracture mechanics
- Concrete Corrosion and Durability
- High-Temperature Coating Behaviors
- Advanced materials and composites
- Advanced machining processes and optimization
- Advanced Photonic Communication Systems
- Advanced Optical Network Technologies
- Advanced Materials Characterization Techniques
- Innovative concrete reinforcement materials
- Non-Destructive Testing Techniques
- Geotechnical Engineering and Soil Mechanics
Universidad Michoacana de San Nicolás de Hidalgo
2016-2025
Manipal Academy of Higher Education
2024
National Research Nuclear University MEPhI
2024
Telefonica Research and Development
2014-2022
Institute of Photonic Sciences
2018
Consejo Nacional de Ciencia y Tecnología
2012-2015
Pemex (Mexico)
2013
Cenim - Centro Nacional de Investigaciones Metalurgicas
2009-2012
Yaroslav-the-Wise Novgorod State University
2011
Tenaris (United States)
2008
The neutral density profile of cylindrical gas jets is measured with a Mach–Zehnder interferometer under wide range backing pressures. sensitivity this diagnostic together the mathematical treatment data allows us to measure densities for argon as low 1017 cm−3 5 mm diam jet.
Laser welding is a very attractive technique to join different alloys at the industrial level, due its low heat input, high flexibility, weld quality and production rate. In this work, weldability of aluminium alloy AA 5083 with power diode laser has been tested. Concisely, samples were subjected lineal treatments radiation, objective studying properties bead on plate welds generated. The main present work study influence both processing rate superficial treatment samples, morphological,...
This paper introduces a novel and simplified cost model for designing evaluating Central Office Rearchitected as Datacenter (CORD). The includes equipment elements the realization of optical, packet switching, data center parts with special focus not only on relative costs but also power consumption figures. is then applied to design comparison metropolitan area network (MAN) including both aggregation metrocore nodes following several MAN node architectures based CORD-like leaf-and-spine...
Pin-on-disk tests were performed to evaluate the wear behaviour of a 2024 aluminium alloy metal matrix composite (MMC) reinforced with 52 vol.% TiC particles (Al-2024/TiC) in fabricated and thermal-treated (T6) condition. The MMC was produced via pressureless infiltration partially sintered preforms an average particle size 1.1 μm at 1200 °C for 2 h under flowing argon. Microstructural mechanical characterisation carried out on both monolithic (MM) without heat treatment. effect T6 treatment...