A5082744560- Welding Techniques and Residual Stresses
- Advanced Welding Techniques Analysis
- Additive Manufacturing Materials and Processes
- Laser Material Processing Techniques
- Non-Destructive Testing Techniques
- Surface Roughness and Optical Measurements
- Advanced Surface Polishing Techniques
- Metal and Thin Film Mechanics
- Hydrogen embrittlement and corrosion behaviors in metals
- Laser-induced spectroscopy and plasma
- Corrosion Behavior and Inhibition
- Laser and Thermal Forming Techniques
- Advanced machining processes and optimization
- Optical Coatings and Gratings
- High Entropy Alloys Studies
- High-Temperature Coating Behaviors
- Diamond and Carbon-based Materials Research
- MXene and MAX Phase Materials
- Engineering Applied Research
- Advanced Measurement and Metrology Techniques
- Advanced optical system design
- Ocular and Laser Science Research
- Supercapacitor Materials and Fabrication
- Additive Manufacturing and 3D Printing Technologies
- Electrocatalysts for Energy Conversion
Xiamen University of Technology
2012-2024
Fujian Electric Power Survey & Design Institute
2017-2023
Xiamen University
2021
Tongji University
2021
Hunan University
2009
The study employed laser scanning welding technology for butt experiments on red copper, investigating the behavior of metal vapor plumes, plasma, and spatter during process, as well quality electrical conductivity resulting joints by varying polarity strength applied magnetic field. results showed that field had a minor effect performance, with main influencing factor being As increased, formation volume ejection intensity plumes plasma exhibited an initial decrease followed increase,...
In this paper, we propose a replication method of thermoplastic polymer spherical lens array using novel microforged mold. The Si3N4 ceramic balls, with 3.5 mm diameter, 10 nm surface roughness and 84 deviation from profile, were utilized as indentor to generate aluminum alloy Upon the optimization technical parameters, such heating de-molding temperature, indentation force holding time, high quality mold was obtained. used fabricate PMMA by hot embossing, which showed excellent...
Ti 3 C 2 T x is a promising new two-dimensional layered material for supercapacitors with good electrical conductivity and chemical stability.
In this paper, three-dimensional cutting test of auto-body panel was carried out by CO<sub>2</sub> laser on the five-axis linkage numerical control machine. First, advantage adopting 3D method to process Auto-body Panel summarized, and essential factor in quality discussed. Then, technical difficulty addressed, several experiments theory analysis problems such as collision overburning at upslope, downslope, corner were conducted, with corresponding improvement methods solutions proposed....
Abstract By combining numerical simulation and experimental investigation, this paper intensively investigated the influence rules of adding three active agents (SiO 2 , TiO NaF) on dynamic behaviors flow field in laser welding 304 stainless steel thick plate pool. First all, mathematical model activating was constructed to numerically investigate impact fluid Secondly, based tungsten particle tracing principle test, high speed camera system adopted for real-time monitoring mechanism action...