Shuai Yan

ORCID: 0000-0002-0913-342X
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • Advanced ceramic materials synthesis
  • Tribology and Wear Analysis
  • Lubricants and Their Additives
  • Advanced materials and composites
  • Additive Manufacturing Materials and Processes
  • Additive Manufacturing and 3D Printing Technologies
  • Metal and Thin Film Mechanics
  • Tribology and Lubrication Engineering
  • Diamond and Carbon-based Materials Research
  • X-ray Diffraction in Crystallography
  • Advanced machining processes and optimization
  • High Entropy Alloys Studies
  • Crystallization and Solubility Studies
  • High-Temperature Coating Behaviors
  • Nuclear materials and radiation effects
  • Ferroelectric and Piezoelectric Materials
  • Adhesion, Friction, and Surface Interactions
  • Advanced Surface Polishing Techniques
  • Microwave Dielectric Ceramics Synthesis
  • Aluminum Alloys Composites Properties
  • Material Properties and Applications
  • Welding Techniques and Residual Stresses
  • Force Microscopy Techniques and Applications
  • Advanced Welding Techniques Analysis
  • Magnetism in coordination complexes

Tianjin University
2016-2025

Hong Kong Polytechnic University
2025

Nanjing University of Science and Technology
2024

University of Science and Technology Liaoning
2023-2024

Zhejiang Ocean University
2024

Qingdao University
2023-2024

Grinm Advanced Materials (China)
2023

Northwest A&F University
2023

Shandong Academy of Agricultural Sciences
2023

Ningbo University of Technology
2023

Abstract Li 2 (Mg 1– x Cu ) Mo 3 O 12 (0 ≤ ≤0.1) ceramics were prepared using the conventional solid‐phase method to study effect of 2+ substitution for Mg on sintering behavior, crystal structure, and microwave dielectric properties ceramics. The experimental results show that reduces temperature 550°C. X‐ray diffraction patterns introduction does not produce a new phase, but rather promotes formation solid solution. are influenced by cell parameters, bond lengths, structural stability....

10.1111/jace.19787 article EN Journal of the American Ceramic Society 2024-03-14

Polyether-ether-ketone (PEEK) and polyimide (PI) are two kinds of engineering polymer materials widely used as roller bearing cages rings under extreme environment because their noise reduction corrosion resistance properties. The Si3N4 ceramic is the most common ball material. Many current applications bearings require aqueous lubrication. Therefore, this study presents lubrication tribopairs formed by PEEK PI material sliding against ceramic. Experimental results show that exhibited...

10.1007/s40544-017-0155-9 article EN cc-by Friction 2017-06-16

Superlubricity has been recognized as the future of tribology. However, it is hard to achieve superlubricity under extreme conditions such a high load and low sliding speed on macroscale. In this paper, remarkable synergetic lubricating effect between nanoparticles silicon nitride (Si3N4) demonstrated; helps water-lubricated Si3N4 successfully. Different kinds hairy silica were prepared, dispersed into water, characterized using variety methods. The tribological properties with nanoparticle...

10.1021/acs.langmuir.9b02337 article EN Langmuir 2019-10-30
Coming Soon ...