A5100761638- High-Temperature Coating Behaviors
- Advanced materials and composites
- Erosion and Abrasive Machining
- Health Systems, Economic Evaluations, Quality of Life
- Metal and Thin Film Mechanics
- Additive Manufacturing and 3D Printing Technologies
- Venous Thromboembolism Diagnosis and Management
- Hydrogen embrittlement and corrosion behaviors in metals
- Metal Alloys Wear and Properties
- High Entropy Alloys Studies
- Additive Manufacturing Materials and Processes
- Nuclear Materials and Properties
- Microstructure and mechanical properties
- Advanced Welding Techniques Analysis
- Aluminum Alloy Microstructure Properties
- Tribology and Wear Analysis
- Cardiac Valve Diseases and Treatments
- Aluminum Alloys Composites Properties
- Mechanical Circulatory Support Devices
- Mechanical Engineering and Vibrations Research
- Coal Combustion and Slurry Processing
- Microstructure and Mechanical Properties of Steels
- Cardiac, Anesthesia and Surgical Outcomes
- Metallurgical Processes and Thermodynamics
- Acute Ischemic Stroke Management
Indian Institute of Toxicology Research
2024-2025
Chandigarh University
2018-2024
John H. Stroger, Jr. Hospital of Cook County
2024
Shaheed Mohtarma Benazir Bhutto Medical University
2024
Chandka Medical College
2024
Punjab Engineering College
2024
Stanford University
2024
Houston Methodist
2024
Louisiana State University in Shreveport
2024
Institute of Medical Sciences
2024
The aim of the current investigation is to evaluate erosion-corrosion (E-C) performance wire arc sprayed Ni-20Cr and Ni-5Al coatings on T22 SA516 boiler steels in a real environment. microstructure, mechanical properties high temperature E-C deposited were investigated. behaviour test samples was determined superheater zone coal fired at 750°C for fifteen cycles, where each cycle involved 100 hours heating followed by 1hour cooling. Thickness loss data used determine coating. XRD, SEM/EDS...
The current study represents the corrosion behavior of wire arc sprayed Ni-based (Ni-5Al and Ni-20Cr) coatings on commonly used boiler tube steels (T11 Gr A1). A cyclic hot samples has been carried out at 900 °C for 50 cycles with application Na2SO4-60%V2O5 salt. offered excellent resistance in comparison to bare steel. surface cross sectional analysis coated before after using SEM/EDS XRD analysis. It was observed that Ni-20Cr coating exhibited better both T11 A1 steel than a Ni-5Al...
A renowned hard coating material (WC–Co) has the potential to overcome cavitation erosion (CE) in hydromachinery components. Hydro turbines that employ silt-filled water for electricity generation create a lot of metal waste due and caused by particles. There is an urgent need repair hydropower components have undergone damage cavitation. In this investigation, tungsten carbide composite coatings were produced on 13Cr4Ni (CA6NM) stainless steel substrates using cold spray method. order...
Cold spraying is a promising technique for depositing wear-resistant coatings on components like hydroturbine steels. This paper highlights the feasibility of hard WC-17Co coating 13Cr4Ni steel. The was deposited at 25, 30, and 40 bar 800 ∘ C 50 900 C. Further, different characterization techniques (SEM, XRD) were used to analyze developed coatings. Vicker hardness testing employed determine coated sample. It observed that offered maximum up 275 Hv, which an excellent quality anti-wear...