A5088318401- Advanced Battery Technologies Research
- Advanced Battery Materials and Technologies
- Advancements in Battery Materials
- Advanced battery technologies research
- Phase Change Materials Research
- Supercapacitor Materials and Fabrication
- Fuel Cells and Related Materials
- Hydrocarbon exploration and reservoir analysis
- Seismic Imaging and Inversion Techniques
- Electric and Hybrid Vehicle Technologies
- Reliability and Maintenance Optimization
- Electrocatalysts for Energy Conversion
- Advanced DC-DC Converters
- Flame retardant materials and properties
- Reservoir Engineering and Simulation Methods
- Seismology and Earthquake Studies
- Polymer composites and self-healing
- Lattice Boltzmann Simulation Studies
- Hybrid Renewable Energy Systems
- Nanomaterials and Printing Technologies
- Refrigeration and Air Conditioning Technologies
- earthquake and tectonic studies
- Hydrological Forecasting Using AI
- Graphene research and applications
- Rock Mechanics and Modeling
Guangdong University of Technology
2016-2025
Guangzhou Panyu Polytechnic
2024-2025
Nanyang Institute of Technology
2024-2025
University of Chinese Academy of Sciences
2022-2025
Chinese Academy of Sciences
2022-2025
Nanyang Polytechnic
2023
University of Hertfordshire
2020
Renmin University of China
2017
State Key Laboratory of Hydrology-Water Resources and Hydraulic Engineering
2012
Nanjing Hydraulic Research Institute
2012
The impact of climate change on floods and droughts in Huaihe River Basin is studied using a coupled land-surface hydrology model continuous wavelet transform technique. Observed temperature the basin has increased by approximately 0.228 °C per decade since 1951. precipitation simulated observed streamflows are used to grade flood drought events. Two composite grading indices derived from three series different weight values defined for reducing uncertainties caused errors observation...
The interface thermal resistance (ITR) of materials is discussed in terms electronic unit heat dissipation. To reduce the ITR heat-conducting silicone grease (HCSG), low melting-point alloys (LMPAs) are introduced using boron nitride nanosheets (BNNS) via a simple route for management. results reveal that LMPAs uniformly compound and coat BNNS at nanometer level. narrows LMPAs' melting range. After reaching point, composite powder shows degree surface wettability. HCSG's conductivity,...
Battery thermal management system (BTMS) based on phase change materials (PCMs) is simple in structure while presenting outstanding performance, but the core bottleneck hindering industrialization of which poor performance PCMs’ pivotal properties. Apart from that, under extreme conditions, single passive temperature‐control technology apparently could not meet demands. Therefore, modification strategies to improve PCM's properties suitable for BTMS are thoroughly reviewed. Moreover,...
ABSTRACT The strategy of mixing adsorption skeleton to obtain composite phase change materials (CPCM) aiming strengthen its thermal stability is confirmed be simple but effective, and CPCM's directly proportional the weight ratio skeleton. However, processability storage density which are inversely content backbone. To relieve above contradiction, this paper proposed an in situ construction method for a phase‐changeable backbone (PCPB). growth avoided processing difficulties caused by high...
Geophysical methods play a crucial role in non-invasive dam monitoring, but traditional techniques often face limitations resolution, depth penetration, and lateral variation detection, which hinder their effectiveness for structural assessments. To address these challenges, we apply full-waveform inversion (FWI) to 375-m-long profile evaluate its potential imaging future monitoring. Seismic data are pre-processed by stacking shots enhance the signal-to-noise ratio (SNR), followed band-pass...
The temperature has to be controlled adequately maintain the electric vehicles (EVs) within a safety range. Using paraffin as heat dissipation source control rise is developed. And expanded graphite (EG) applied improve thermal conductivity. In this study, and EG composite phase change material (PCM) was prepared characterized. then, PCM have been in 42110 LiFePO 4 battery module (48 V/10 Ah) for experimental research. Different discharge rate pulse experiments were carried out at various...