A5029660210- Additive Manufacturing and 3D Printing Technologies
- Additive Manufacturing Materials and Processes
- Advanced machining processes and optimization
- Advanced Machining and Optimization Techniques
- Advanced Surface Polishing Techniques
- High Entropy Alloys Studies
- Manufacturing Process and Optimization
- Injection Molding Process and Properties
- Innovations in Concrete and Construction Materials
- Bone Tissue Engineering Materials
- Titanium Alloys Microstructure and Properties
- Laser Material Processing Techniques
- Welding Techniques and Residual Stresses
- Advanced Sensor and Energy Harvesting Materials
- Aluminum Alloys Composites Properties
- Advanced materials and composites
- 3D Printing in Biomedical Research
- Cellular and Composite Structures
- Hydrogels: synthesis, properties, applications
- Conducting polymers and applications
- Metal and Thin Film Mechanics
- Mechanical Behavior of Composites
- Electrospun Nanofibers in Biomedical Applications
- Metallurgy and Material Forming
- Nanomaterials and Printing Technologies
Binghamton University
2018-2025
Vesta Sciences (United States)
2025
Texas Tech University
2015-2018
Lubbock Christian University
2015
Dalian University of Technology
2014
Carbon fiber-reinforced plastic composites have been intensively used for many applications due to their attractive properties. The increasing demand of carbon is driving novel manufacturing processes be in short cycle time and low production cost, which difficult realize during fabrication common molding processes. Fused deposition modeling, as one the additive techniques, has reported fabricating composites. process parameters fused modeling follow those pure materials. After adding fiber...
A super tough hydrogel with tunable mechanical properties was 3D printed.
Fused deposition modeling is a fast growing additive manufacturing technology with advantages of low cost, operation temperature, consistent prototype accuracy, and flexible material change. Fiber-reinforced plastic composite parts have been developed by the fused process to improve mechanical properties modeling-fabricated pure thermoplastic which cannot be used as load-bearing in actual applications. However, porosity found at fracture interfaces fiber-reinforced may limit their potential...
In this study, calcium alginate/agar (CA/Ag) 3D structures were printed as strip assembles with high resolution and tailorable mechanical properties by a thermal-assisted printing method. Specifically, alginate agar combined to minimize the Barus effect, further improved resolution. The introduction of altered rheological ink, such increasing its viscosity obtain structure higher precision. chains crosslinked ions, which connected different layers together had good interface adhesion among...
Abstract Extrusion-based sintering-assisted additive manufacturing (ES-AM) has enabled the fabrication of intricate metal structures, spanning from simple geometries to complex lattice structures. The sintering process plays a vital role in densification that requires effective design and optimization processes for high-quality sintered parts. Notably, behaviors ES-AM differ those traditional methods, primarily due heterogeneous distribution particles pores induced by anisotropic nature AM....
This paper explores the specific energy consumption (SEC) and environmental impacts for typical additive manufacturing processes. Also, examines possibility that ensure product quality while reducing with experimental analysis. The results show (1) SEC of processes is related not only to material characteristics but also process input parameters; (2) it possible increase efficiency without by adjusting rate or selecting different materials; (3) global warming potential (GWP) result AM...
Laser engineered net shaping (LENS) has been applied as a key technology in direct manufacturing or repairing of high added- value metal parts. Recently, many investigations on LENS Inconel 718 parts have conducted for potential applications the aircraft turbine component repairing. However, fabrication defects such pores, cavities, and heterogeneous microstructures always exist parts, affecting part qualities mechanical properties. Therefore, it is crucial to LENS-manufacture high-quality...