A5100353081- Thermochemical Biomass Conversion Processes
- Granular flow and fluidized beds
- Iron and Steelmaking Processes
- Cyclone Separators and Fluid Dynamics
- Chemical Looping and Thermochemical Processes
- Combustion and flame dynamics
- Heat transfer and supercritical fluids
- Catalytic Processes in Materials Science
- Industrial Gas Emission Control
- Climate variability and models
- Particle Dynamics in Fluid Flows
- Meteorological Phenomena and Simulations
- Mineral Processing and Grinding
- Adsorption and Cooling Systems
- Coal and Its By-products
- Coal Properties and Utilization
- Hydrology and Watershed Management Studies
- Coal Combustion and Slurry Processing
- Soil and Water Nutrient Dynamics
- Aerosol Filtration and Electrostatic Precipitation
- Geological and Geochemical Analysis
- Recycling and utilization of industrial and municipal waste in materials production
- Radiative Heat Transfer Studies
- Advanced Combustion Engine Technologies
- Advanced Battery Technologies Research
Tsinghua University
2016-2025
China University of Geosciences (Beijing)
2022-2024
Civil Aviation Administration of China
2024
NOAA Earth System Research Laboratory
2020-2023
National Oceanic and Atmospheric Administration
2020-2023
Harbin Normal University
2021-2023
State Key Laboratory of Power System and Generation Equipment
2021-2023
Cooperative Institute for Research in Environmental Sciences
2020-2023
University of Colorado Boulder
2014-2023
Beijing University of Civil Engineering and Architecture
2023
With the increasingly serious problems of energy shortage and environmental degradation, countries around world are actively developing safe, environmentally friendly, renewable energy. Biomass has become an ideal substitute for fossil fuels due to its abundant reserves, good performance, zero carbon emissions. This paper discusses importance potential biomass as a source China’s development, mainly including three conversion methods physics, chemistry, biology, seven utilization...
Abstract Pipeline transportation is the most practically used means to deliver crude oil before it enters refining factories. External heating on pipelines routinely needed in order make flow easier, especially areas with low ambient temperature, which has involve tremendous energy consumption and causes a significant increase costs. Here, green cost‐effective strategy of “photothermal clothing” conceived by pipeline only warmed sunlight based photothermal conversion. The material complex...
Thermal energy storage is an essential technology for improving the utilization rate of solar and efficiency industrial processes. Heat release by dehydration rehydration Ca(OH)2 are hot topics in thermochemical heat storage. Previous studies have described different methods thermodynamic, kinetic, structural stability to improve density, rate, cycle stability, respectively. Here, mechanisms effects techniques on performance improvement some common problems were reviewed. Specific also...
This paper focuses on the critical role of long-duration energy storage (LDES) technologies in facilitating renewable integration and achieving carbon neutrality. It presents a systematic review four primary categories: mechanical storage, chemical electrochemical thermal storage. The study begins by analyzing technical advantages geographical constraints pumped hydro (PHES) compressed air (CAES) high-capacity applications. then explores potential hydrogen synthetic fuels for clean section...
The temperature of flue gas should be controlled to higher than the acid dew point avoid fouling and corrosion heating surfaces in second pass boilers. Decreasing boilers is one most effective ways improve thermal efficiency, enhance electrostatic precipitator decrease water consumption desulfurization tower. Accurate knowledge predicting required. Thus, based on previous research achievements, a measuring device designed principle conductive meter, points under different conditions are...
Accurate real-time water quality prediction is of great significance for local environmental managers to deal with upcoming events and emergencies develop best management practices. In this study, the performances in forecasting based on different deep learning (DL) models input data pre-processing methods were compared. There three popular DL concerned, including convolutional neural network (CNN), long short-term memory (LSTM), hybrid CNN–LSTM. Two types applied, original one-dimensional...
Wet fluidized bed granulation and coating processes have been widely used in the pharmaceutical food industries. The complex gas–solid flow coupled with heat mass transfer such made it hard to form complete control over apparatuses. To serve better design, scaling-up, optimization of granulators coaters, underlying micro-scale mechanisms must be clarified. Computational fluid dynamics discrete element method (CFD-DEM) provides a useful tool study in-depth gas-solid hydrodynamics processes....
Abstract Background error modeling plays a key role in variational data assimilation system. The National Meteorological Center (NMC) method has been widely used systems to generate forecast ensemble from which the climatological background covariance can be modeled. In this paper, characteristics of via NMC are investigated for system Weather Research and Forecasting (WRF-Var) Model. statistics extracted short-term 3-km-resolution forecasts June, July, August 2012 over limited-area domain....
The conserved phosphatidylserine receptor (PSR) was first identified as a for phosphatidylserine, an 'eat-me' signal exposed by apoptotic cells. However, several studies suggest that PSR may also act arginine demethylase, lysyl hydroxylase, or RNA-binding protein through its N-terminal JmjC domain. How might execute drastically different biochemical activities, and whether they are physiologically significant, remain unclear. Here we report lysine-rich motif in the extracellular domain of...