The wireless power transfer (WPT) system holds potential as a viable solution for charging electric vehicles (EVs) owing to its benefits including safety, automated operation, efficiency, and simplicity. Among the WPT technologies, inductive (IPT) stands out particularly well-suited EV batteries. This is primarily due capability transmit high across considerable air gap distances, accommodating ground clearance requirements of most EVs, operating automatically without driver involvement,...

This paper introduces a physical–chemical model that governs the lithium ion (Li-ion) battery performance. It starts from of life and moves forward with simplifications based on single-particle (SPM), until arriving at more simplified computationally fast model. On other hand, implementation this is developed through MATLAB. The goal to characterize an Li-ion cell obtain its charging discharging curves different current rates cycle depths, as well transitory response. In addition, results...

Wind Energy has received great attention in this century. It influences the new power systems, adding challenges to system expansion problem. Nowadays, double feed induction generator (DFIG) wind turbines are used majorly farms, due their advantages over other types. Therefore, analysis of using type become very important. In paper, a turbine modelling was introduced with suggested controllers, order enhance response, respect both pitch control and maximum output power. Cuckoo search...

Switched reluctance motors (SRMs) received major interest in several domains, e.g., electric vehicles. This is due to the many advantages of SRMs, including operation at a wide range speeds, high performances, low cost, robustness run under degraded conditions, and controllability. One aspects design implementation controllers for SRMs estimation motor parameters. An accurate estimate these parameters challenge highly nonlinear behavior addition their magnetic saturated operating mode...

The problem of AC corrosion remains motivating for researchers because many factors influence the rate buried pipelines due to interference with overhead high voltage transmission lines (OHVTLs). Many study mechanisms induced alternating current (AC) voltages, which are summarized as capacitive, inductive, and conductive coupling. In this work, only on inductive coupling in steady-state conditions is studied. A holistic mathematical model pipelines, power lines, mitigation equipment voltage,...

To link DC power sources to an AC grid, converters are needed. Inverters the electronic devices, which used for this purpose. Conventional inverters employ harmonic filters and transformers that lossy expensive. Multilevel (MLIs) alternative conventional ones, proposing reduced total distortion (THD), increased range of control, inductor-less design. They generate a stepped waveform, with close similarity sine wave. Many distributed may be employed in smart grid. If those have minimal THD,...

Due to their favorable characteristics, lithium-ion batteries have a dominant share of the battery market. There are number issues related use and management Lithium-ion in this paper, specifically with regard safe operation as well methods for balancing cells. With help passive cell algorithm measurement circuit, system has been developed. The purpose paper is improve efficiency by implementing analyzing modelling method from literature, aim improving its performance. results study showed...

Theoretically, the output of wind turbine might be estimated based most known power equation that depends mainly in speed. There are many issues appeared phase estimating and control while applying this due to ignoring weather conditions. This paper introduces a multivariate estimation for curve considering conditions such as speed, air density, turbulence, share. variables termed features, lot measurement has been occurred collect all possible data these where measurements (system data)...

Renewable energy has become one of the most resources nowadays, especially, wind energy. It is important to implement more analysis and develop new control algorithms due rapid changes in generators size power electronics development applications. This paper proposes a grid-connected conversion system (WECS) scheme using permanent magnet synchronous generator (PMSG). The model works improve delivered quality maximize its value. contained controller on grid side converter (GSC) two simulation...

Download This Paper Open PDF in Browser Add to My Library Share: Permalink Using these links will ensure access this page indefinitely Copy URL DOI

This paper aims to optimize the losses of current manufacturing systems perform Just in Time (JIT) system and minimize time, labor, material process. Pull systems, which have a famous name Smart Kanban system, are one methodologies implement JIT system. The setting frameworks offers intriguing capabilities improve performance pull-controlled creation frameworks. can be utilized, rather than actual cards, data conversion about settings, is accessible through sensors. Since Just-in-Time does...

In recent years, optimization techniques have been developed to improve accuracy and reduce execution time. The moth flame technique (MFO) adapts behavior. This design is based on the moth's transverse orientation. Over long distances, they maintain a fixed angle with respect moon at night. They spiral around lights, however. Moths are trapped in deadly as light approaches; eventually, all converge it. Furthermore, created by artificial fly similarly. To maximize power delivered grid, used...