A5058733496- Graphene research and applications
- Boron and Carbon Nanomaterials Research
- Nanopore and Nanochannel Transport Studies
- Structural Engineering and Vibration Analysis
- Carbon Nanotubes in Composites
- Advanced ceramic materials synthesis
- Structural Analysis and Optimization
- Structural Behavior of Reinforced Concrete
- Particle Dynamics in Fluid Flows
- Composite Material Mechanics
- High-Velocity Impact and Material Behavior
- Diamond and Carbon-based Materials Research
- 2D Materials and Applications
- Numerical methods in engineering
- MXene and MAX Phase Materials
- Structural Response to Dynamic Loads
- Seismic and Structural Analysis of Tall Buildings
- Seismic Performance and Analysis
- Metallurgy and Material Forming
- Aeroelasticity and Vibration Control
- Granular flow and fluidized beds
- Wind and Air Flow Studies
- Ion-surface interactions and analysis
- Fire effects on concrete materials
- Composite Structure Analysis and Optimization
Bauhaus-Universität Weimar
2016-2020
University of Tabriz
2016
University of Technology Malaysia
2013-2015
Abstract Macro fiber composite (MFC) actuators developed by the NASA have been increasingly used in engineering structures due to their high actuation power, compatibility, and flexibility. In this study, an efficient two dimensional quadratic multi-layer shell element using first order shear deformation theory (FOSDT) is predict linear strain–displacement static of laminated plates induced MFC actuators. FOSDT adapted from Reissner–Mindlin plate theory. An eight-node piezoelectric with five...
A comprehensive model was derived based on the balance between drag, collision, and gravity as separation van der Waals hydrogen bond adhesion forces to estimate equilibrium size of agglomerates formed during fluidization nanoparticles. Due approximately less than 9% total amount forces, drag collision were not considered in final model. Also, influence using vapor different alcohols behavior hydrophilic silica alumina nanoparticles studied by experiments. To justify improving effect...
The main objective of this study was to obtain the correlation between severity damage stiffness frame in format its intrinsic dynamic properties, natural frequency structural system at damaged and undamaged state. In research, a laboratory test performed on precast post-tension similar dimension strength specification Jabatan Kerja Raya (JKR) school buildings. modal is reduced scale 1 5 subjected cyclic lateral loadings monitored through vibration test. each end cycle pushover data recorded...
Many failures such as those due to blast, impact, wind pressure and earthquakes can be caused by the progressive collapse in structures.This paper will discuss different mitigation methods for corresponding numerical analysis a 9-storey reinforced concrete structure SAP2000 following severe initial damage.After removing specified critical columns demand capacity ratio (DCR) of members measured latest revision Department Defence United States (DOD) guideline, which is one most complete sets...