A5033502404- Combustion and flame dynamics
- Radiative Heat Transfer Studies
- Advanced Combustion Engine Technologies
- Catalytic Processes in Materials Science
- Heat and Mass Transfer in Porous Media
- Thermochemical Biomass Conversion Processes
- Heat transfer and supercritical fluids
- Fire dynamics and safety research
- Catalysis and Oxidation Reactions
- Combustion and Detonation Processes
- Adsorption and Cooling Systems
- Fault Detection and Control Systems
- Advanced Control Systems Optimization
- Phase Change Materials Research
- Iron and Steelmaking Processes
- Catalysts for Methane Reforming
- Adsorption and biosorption for pollutant removal
- Granular flow and fluidized beds
- Process Optimization and Integration
- Chemical Looping and Thermochemical Processes
- Particle Dynamics in Fluid Flows
- Industrial Gas Emission Control
- Constructed Wetlands for Wastewater Treatment
- Wind and Air Flow Studies
- Reservoir Engineering and Simulation Methods
Shandong University of Technology
2015-2024
Guizhou University
2022
Guizhou Academy of Agricultural Sciences
2022
East China University of Science and Technology
2015
Recently, rampant eutrophication induced by phosphorus enrichment in water has been attracting attention worldwide. However, the mechanisms which phosphate can be eliminated from aqueous environment remain unclear. This study was aimed at investigating adsorption performance and regulation of zeolite-biochar composite for removing an environment. To do this, physicochemical properties were assessed Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM),...
A differential evolution (DE) algorithm for determining 16 advanced turning model parameters of a 1.2 million industrial fluid catalytic cracking (FCC) unit modeling by HYSYS 8.4 is presented. Industrial data from Chinese petroleum refinery were used to develop, train and check the model. Due FCC complexity, proposed capable predicting yield products based on main operating conditions. The optimized further analysis conditions maximum economic benefits. Prediction benefit increases 917 yuan/h at
Numerical investigations on partial oxidation combustion of CO2/CH4 mixture were executed for a two-layer burner using two-dimensional two-temperature model with different detailed chemical reaction mechanisms that are DRM 19, GRI-Mech 1.2 and 3.0. Attention was focused the influence these predictions temperature distributions in burner, structure as well syngas production. The equivalence ratio fixed value 1.5, while CO2 to CH4 changed from 0 1. predicted results compared available...
This paper reports the results of experimental investigation flow resistance in a coal mine ventilation air methane preheated catalytic oxidation reactor. The system was installed at Energy Research Institute Shandong University Technology. has been used to investigate effects rate (200 Nm 3 /h 1000 /h) and bed average temperature (20°C 560°C) within pressure drop proportion bed, heat exchanger preheating section, flue gas section were measured. In addition, based on large number data,...
Experimental and numerical studies were conducted to determine the combustion characteristics of gas diffusion in a porous combustor packed with 2.5 mm or 3.5 alumina pellets, special attention being focused on effect bed height ( h ) combustion, NO CO emissions. The pollutant emission filtration is studied different lengths range 40 ≤ 240 mm, fixed excess air ratio 1.88 inlet velocity 0.06 m s −1 . Results show that both immersed surface flames coexist combustor. Although media enhance...
We performed pore-level simulation of fuel-rich partial oxidation a CO2/CH4 mixture in two-dimensional porous burner with staggered arrangement discrete particles. The chemistry was treated detailed chemical kinetics GRI-Mech 1.2, and surface-to-surface radiation taken into account by the ordinates (DO) model. predicted results were validated against available experimental data volume-averaged method. main syngas products (CO, H2, CO2) agreed well for whole investigation range; it indicated...
In experimental investigations on axial symmetry, over-ventilated CH 4 /air diffusion combustion in a packed bed is executed to study the height, shape and stability of flame. The combustor quartz tube with alumina pellets which cylindrical fuel stream surrounded by coflow air nozzle. results show that length pellet diameter have significant influence flame properties. general, above surface has its colour are similar those conventional when smaller. front varies length. changed indicates an...
The superadiabatic combustion for non-stationary filtration is analytically studied. non-dimensional excess enthalpy function (H) equation theoretically derived based on a one-dimensional, two-temperature model. In contrast to the H stationary combustion, new term, which takes into account effect of wave speed, included in transient combustion. governing equations with boundary conditions are solved by commercial software Fluent. predictions show that maximum gas and solid temperatures flame...