A5024888646- Aerosol Filtration and Electrostatic Precipitation
- Cyclone Separators and Fluid Dynamics
- Granular flow and fluidized beds
- Zeolite Catalysis and Synthesis
- Particle Dynamics in Fluid Flows
- Lattice Boltzmann Simulation Studies
- Coal and Its By-products
- Crystallization and Solubility Studies
- Electrostatics and Colloid Interactions
- GaN-based semiconductor devices and materials
- Mineral Processing and Grinding
- Minerals Flotation and Separation Techniques
- Microwave-Assisted Synthesis and Applications
- Recycling and utilization of industrial and municipal waste in materials production
- Adsorption and biosorption for pollutant removal
- Clay minerals and soil interactions
- Chemical Synthesis and Characterization
- Oral microbiology and periodontitis research
- Microfluidic and Bio-sensing Technologies
- Thermochemical Biomass Conversion Processes
- Ranque-Hilsch vortex tube
- Gas Sensing Nanomaterials and Sensors
- Thin-Film Transistor Technologies
- Ga2O3 and related materials
- X-ray Spectroscopy and Fluorescence Analysis
Hiroshima University
2015-2024
Osaka Medical and Pharmaceutical University
2019-2021
National Institute of Diabetes and Digestive and Kidney Diseases
2020
ProQuest (United States)
2020
Osaka International Cancer Institute
2017
University of Fukui
2001-2014
University of Hyogo
2005-2011
Fukushima Medical University
2008
Fukui University of Technology
1991-2005
Oki Electric Industry (Japan)
2005
Transparent conductive indium-tin oxide thin films were prepared by an atmospheric-pressure chemical vapor deposition method. The source materials indium acetylacetonate and tin (II) which are nontoxic easy to handle. polycrystalline obtained at a reaction temperature in the range of 350–500 °C. For 215-nm-thick film deposited 450 °C, resistivity was 1.8 × 10−4 Ω cm, transmittance more than 90% wave number above 400 nm. atomic ratio Sn/In 0.031. effects doping on structure characteristics...
IEEE standard 802.15.4 defines the physical (PHY) and medium access control (MAC) layers for low-cost very low-power short-range wireless communications. One of promising applications offered by is sensor networks. To begin with, this paper shows propagation characteristics radio signal in indoor environments such as "power decay factor" due to near/far effect "fading distribution." Then, presents a network system location estimation which utilizes only received strength indicator (RSSI)...
Seventy-six teeth from open canals were extracted to prepare serial longitudinal sections. The sections made apical portions of the and stained. Ninety similar dentinal splinters with files enlarged infected canal. spread on a selected medium grow S. mutans. mutans was detected in 48.7% 76 examined. distance invasion tubules revealed by immunofluorescence averaged 509 micrometer canal wall reached 1150 micrometer, depending serogroups Unidentified germs which demonstrated Gram's stain...
van der Waals forces, which are attractive interactions between electroneutral particles and fibers, not as widely recognized other collection mechanisms in fibrous filters. We developed a numerical model by combining computational fluid dynamics (CFD) discrete phase (DPM) to predict the impact of forces on particle filter microstructures. The results were extended establish an empirical for efficiency due forces. microstructure was constructed using artificial three-dimensional (3D) domain...
Owing to the limitations of visualization techniques in experimental studies and low-resolution numerical models based on computational fluid dynamics (CFD), detailed behavior oil droplets during microfiltration is not well understood. Hence, a high-resolution CFD model an in-house direct simulation (DNS) code was constructed this study analyze oil-in-water (O/W) emulsion using membrane. The realistic microporous structure commercial ceramic membranes (mullite α-alumina membranes) obtained...
A leukotoxin of Actinobacillus actinomycetemcomitans 301-b was solubilized from cell-associated membrane vesicles by treatment with externally added DNase and RNase further purified a procedure which included ammonium sulfate fractionation, gel filtration chromatography, ion-exchange chromatography. The toxin had molecular mass 113,000 Da sodium dodecyl sulfate-polyacrylamide electrophoresis high isoelectric point (approximately 8.8). From these characteristics, it to be expected that the...