A5100373771- Fire dynamics and safety research
- Solar Thermal and Photovoltaic Systems
- Photovoltaic System Optimization Techniques
- Advanced Thermoelectric Materials and Devices
- Thermal Radiation and Cooling Technologies
- Combustion and Detonation Processes
- Catalytic Processes in Materials Science
- Solar Radiation and Photovoltaics
- Advanced Battery Technologies Research
- Advancements in Battery Materials
- Catalysts for Methane Reforming
- Cavitation Phenomena in Pumps
- Evacuation and Crowd Dynamics
- Advanced Battery Materials and Technologies
- Combustion and flame dynamics
- Urban Heat Island Mitigation
- Microfinance and Financial Inclusion
- Heat Transfer and Optimization
- Catalysis and Oxidation Reactions
- Flame retardant materials and properties
- solar cell performance optimization
- FinTech, Crowdfunding, Digital Finance
- Building Energy and Comfort Optimization
- Chemical Looping and Thermochemical Processes
- Environmental Education and Sustainability
Sichuan Normal University
2025
University of Science and Technology of China
2014-2023
California Institute of Technology
2021
Henan Normal University
2021
Zhengzhou University
2021
Xinxiang Medical University
2021
Ariel University
2021
Anhui Provincial Hospital
2020
Chinese University of Hong Kong, Shenzhen
2019
Chang'an University
2019
Electrical efficiency can be increased by combining photovoltaic (PV) and the thermoelectric (TE) systems. However, a simple cursory combination is unsuitable because negative impact of temperature on PV may greater than its positive TE. This study analyzed primary constraint conditions based hybrid system model consisting TE generator (TEG), which includes material with temperature-dependent properties. The influences geometric size, solar irradiation cold side performance discussed...
In China, because of the emergence a large number high-rise buildings, solar hot water heater system often uses balcony wall-mounted method for installation. The thermoelectric energy converter is proposed as one possible technologies to incorporate produce electricity building application. this paper, conceptual development and theoretical analysis novel micro-channel heat pipe evacuated tube collector-incorporated generation are all proposed. new takes into account many advantages,...
The output power of a photovoltaic (PV) system depends on the external solar irradiation and its own temperature. In order to obtain more from PV system, maximum point tracking (MPPT) is necessary. However, when partially shaded, there will be multiple peaks in power-current (P-I) curve. conventional MPPT methods may invalid due falling into local peak. addition, photovoltaic-thermal (PV/T) non-uniform temperature distribution also occur, which complicates situation. This paper presents...
Geometrical optimisation is a valuable way to improve the efficiency of thermoelectric element (TE). In hybrid photovoltaic-thermoelectric (PV-TE) system, photovoltaic (PV) and (TE) components have relatively complex relationship; their individual effects mean that geometrical TE alone may not be sufficient optimize entire PV–TE system. this paper, we introduce parametric geometry footprint for A uni-couple model was built using finite method temperature-dependent material properties. Two...
In this article, some of the combustion properties three carbonate solvent mixtures commonly used as electrolytes lithium ion batteries are considered by means ISO 5660 cone calorimeter. Experimental findings reveal that heat release rate, most important parameter in fire science, exhibits a significant variation among mixtures. Other key parameters governing fire-induced hazards such total release, mass loss efficiency, and concentration major exhaust gases also determined analyzed....
Expansion joints of bridge superstructures generally suffer deterioration more severely than their main structures, and actual service life is shorter design life. This paper aims at evaluating the wear condition slide bearings in expansion for long-span suspension bridges under monitored traffic flow operation stage. The spring element was introduced to model joint verified by field load tests. vehicle−bridge dynamic analysis on a steel truss girder realized nonlinear system, which...
This study developed a portable arc iKnife ionization mass spectrometry (AII-MS) technique integrating surgical knife with low-temperature plasma to interact plant tissues. The thermal energy from the induces sputtering of water-containing tissues, leading formation aerosols. These aerosols are then charged by plasma-generated ions, producing microdroplets that ultimately detected spectrometer. AII-MS effectively mitigates challenges aerosol or tissue charring associated ionization....
A series of experimental and theoretical works are performed to enrich the previous research concerning single water drop impacting on burning ethanol surface. Three typical impact regimes including crater-first-jet, crater-second-jet, surface bubble discussed in detail, an regime map is built up. For crater-first-jet crater-second-jet regimes, dimensionless maximum crater depth increases with Weber number, but there a sharp decrease for transitioning from bubble. In addition, jet length...