A5023974828- Antenna Design and Analysis
- Millimeter-Wave Propagation and Modeling
- Hybrid Renewable Energy Systems
- Electric Vehicles and Infrastructure
- Advanced Battery Technologies Research
- Microwave Engineering and Waveguides
- Microgrid Control and Optimization
- Energy and Environment Impacts
- Advanced MIMO Systems Optimization
- Electric and Hybrid Vehicle Technologies
- Smart Grid Energy Management
- Energy Harvesting in Wireless Networks
- Vehicular Ad Hoc Networks (VANETs)
- Thermal Analysis in Power Transmission
- UAV Applications and Optimization
- Microwave and Dielectric Measurement Techniques
- Optimal Power Flow Distribution
- High voltage insulation and dielectric phenomena
- Opportunistic and Delay-Tolerant Networks
- Semiconductor materials and interfaces
- Antenna Design and Optimization
- IoT-based Smart Home Systems
- Electrical Fault Detection and Protection
- Photovoltaic System Optimization Techniques
- Soil Moisture and Remote Sensing
Istanbul Technical University
2024
Karabük University
2016-2024
Istanbul Commerce University
2022
University of Iceland
2022
In this study, energy demand of a faculty was aimed to supply with hybrid system (HES) consisting photovoltaic (PV) panels, wind turbine (WT) and bomass (BM) optimum power usage distribution sized reach lowest cost reliable system. optimization, total net present (TNPC) for economic analysis, loss probability (LPSP) reliability, localized (LCOE) determining the unit were considered an effective control algorithm developed decide source improving reliability. We used genetic (GA) simulated...
In this study, we designed a high-performance, compact E-shaped microstrip antenna optimized for intelligent transportation systems, operating at 5.8 GHz. Utilizing simulation tools such as CST Studio Suite 2022 Learning Edition, Ansys HFSS R1, and MATLAB 2022b PCB Antenna Designer, ensured consistent physical parameters. Fabricated with 1.6 mm thick FR-4 substrate 50 Ω line-feeding technique, the measures 35 × mm³, smaller than already existing designs. At 5.75 GHz, it exhibits return loss...
In this proposed paper, a single band microstrip patch antenna for fifth generation (5G) wireless application was presented. 28, 38, 60 and 73 GHz frequency bands have been allocated 5G mobile communications by International Telecommunications Union (ITU). we an antenna, which is suitable the millimeter wave frequency. The consists of new slot loaded on radiating with 50 ohms line feeding used. This simulated FR4 dielectric substrate relative permittivity 4.4, loss tangent 0.02, height 1.6...
Because of fossil fuel shortage and its damages on environment, electric vehicles (EV) are going to be more popular in science car industry as well. So, EV's take an opportunity spread over the traffic finally. But battery, which is main energy supplier motor, has disadvantages big volume weight. Scientists try enhance densities, ranges quicken charging. All research results force us drive EV a loop, close charging stations for near future. So should designed by considering urban road speed...
In the 5 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">th</sup> generation mobile communication (5G) system, better bitrate, power consumption, and Bit Error Rate are needed. To meet all these requirements in 5G, waveform is important. Although Orthogonal Frequency Division Multiplexing (OFDM) modulation scheme has been commonly used 4G, it difficult to of 5G. A lot candidate waveforms discussed 5G system included Filter Bank Multicarrier...
Abstract In this proposed paper, a single band microstrip patch antenna for fifth generation (5G) wireless application was presented. 28, 38, 60 and 73 GHz frequency bands have been allocated 5G mobile communications by International Telecommunications Union (ITU). we an antenna, which is suitable the millimeter wave frequency. The consists of new slot loaded on radiating with 50 ohms line feeding used. This simulated FR4 dielectric substrate relative permittivity 4.4, loss tangent 0.02,...
Detecting snow-covered solar panels is crucial as it allows us to remove snow using heating techniques more efficiently and restores the photovoltaic system proper operation. This paper presents classification detection performance analyses for panel images. The analysis consists of two cases, one case based on three backbones. In this study, five deep learning models, namely visual geometry group-16 (VGG-16), VGG-19, residual neural network-18 (RESNET-18), RESNET-50, RESNET-101, are used...
Flying Ad-hoc Network (FANET) is one among the emerging technology and it used in huge application of intelligent communication system. FANETs are combined with multiple Unmanned Aerial Vehicles (UAVs) to control complex environment. Due high mobility computation overhead delay network greatly increased that reflects reduction performance FANETs. So becomes very essential provide effective routing optimization maintain stable communication. For purpose, this paper Multi-Objective Hybrid...
A solar electric vehicle (SEV) is an (EV) with onboard photovoltaic cells charging a set of batteries for extended driving range. This study aimed to improve the energ ...
Due to the integration of various distributed generation resources into power systems, in particular, proton exchange membrane fuel cell (PEMFC), electrical grid (EPG) becomes more comprehensive and has quality (PQ) issues like voltage/current unbalance, harmonics, voltage sag, etc. The issue sag arises from sudden changes EPG operating conditions. In this paper, Advanced Equilibrium Optimizer (AEO) Particle Swarm Optimization (PSO) are proposed as solutions for disturbance partially caused...
In this proposed paper, a single band microstrip patch antenna for fifth generation (5G) wireless application was presented. 28, 38, 60 and 73 GHz frequency bands have been allocated 5G mobile communications by International Telecommunications Union (ITU). we an antenna, which is suitable the millimeter wave frequency. The consists of new slot loaded on radiating with 50 ohms line feeding used. This simulated FR4 dielectric substrate relative permittivity 4.4, loss tangent 0.02, height 1.6...
In this paper, we proposed a compact microstrip monopole antenna, for fifth generation (5G), can operating in millimeter wave (mmWave) communication. It is consisted of RO4003 with thickness 0.203 mm and it was designed as planar-fed single-band by placing quarter circular slots on rectangular patch, simple structure. Thus, the antenna simulated Ansys HFSS module various parameters such radiation performance ante006Ena gain were obtained single frequency range. The return-loss bandwidth...
To design an efficient, sustainable and feasible hybrid system sizing optimization should be applied. In this study, a power plant, which consists of off-grid PV wind energy to supply the demand solar research center in Libya, was designed. Crow search technique applied decrease installation cost operating by each part system. We optimized number modules, powers turbines capacities batteries. After offering system, we compared performance crow algorithm with particle swarm performance....
Material characterisation plays a crucial role in many applications such as security, military, communication, bioengineering, medical treatment, food industry and material processing. Since it is useful to identify other properties of materials often tied parameters, stress–strain relation, bio content, moisture density so on, the dielectric should be achieved with high accuracy using appropriate measurement techniques extraction techniques. There are methods determine materials, which...