A5103144541- Electrical and Bioimpedance Tomography
- Flow Measurement and Analysis
- Non-Destructive Testing Techniques
- Geophysical and Geoelectrical Methods
- Spectroscopy and Chemometric Analyses
- Advanced X-ray and CT Imaging
- Microfluidic and Capillary Electrophoresis Applications
- Microfluidic and Bio-sensing Technologies
- Medical Imaging Techniques and Applications
- Analytical Chemistry and Sensors
- Sensor Technology and Measurement Systems
- Water Quality Monitoring and Analysis
- Optical Imaging and Spectroscopy Techniques
- Non-Invasive Vital Sign Monitoring
- Geophysical Methods and Applications
- Intravenous Infusion Technology and Safety
- Advanced Chemical Sensor Technologies
- Electrowetting and Microfluidic Technologies
- Spectroscopy Techniques in Biomedical and Chemical Research
- Magnetic Field Sensors Techniques
- Nuclear Physics and Applications
- Solar Thermal and Photovoltaic Systems
- Image and Object Detection Techniques
- solar cell performance optimization
- Photovoltaic System Optimization Techniques
University of Technology Malaysia
2014-2024
Tun Hussein Onn University of Malaysia
2017-2024
Newcastle University Medicine Malaysia
2020
Institute for Infocomm Research
2015
Digital Research Alliance of Canada
2015
Innovative Technology Applications (United States)
2015
Nature Conservation Centre
2012
Sheffield Hallam University
1995-1996
Electrical charge tomography (EChT) is a non-invasive imaging technique that aimed to reconstruct the image of materials being conveyed based on data measured by an electrodynamics sensor installed around pipe. Image reconstruction in electrical vital and has not been widely studied before. Three methods have introduced before, namely linear back projection method, filtered method least square method. These normally face ill-posed problems their solutions are unstable inaccurate. In order...
This paper demonstrates a modular architecture of non-contact actuation micropump setup. Rapid hot embossing prototyping was employed in fabrication by using printed circuit board (PCB) as mold material polymer casting. Actuator-membrane gap separation studied, with experimental investigation three distances: 2.0 mm, 2.5 mm and 3.5 mm. To enhance the performance, interaction surface area between plunger membrane modeled via finite element analysis (FEA). The evaluated against two frequency...