A5080674975- Advanced Thermoelectric Materials and Devices
- Heat Transfer and Optimization
- Thermal Radiation and Cooling Technologies
- Thermal properties of materials
- Epoxy Resin Curing Processes
- Refrigeration and Air Conditioning Technologies
- Textile materials and evaluations
- Advanced Thermodynamics and Statistical Mechanics
- Mechanical Behavior of Composites
- Engineering Applied Research
- Advanced Fiber Optic Sensors
- Optical measurement and interference techniques
- earthquake and tectonic studies
- Quantum Information and Cryptography
- Recycling and Waste Management Techniques
- High-pressure geophysics and materials
- Quantum Computing Algorithms and Architecture
- Advanced Combustion Engine Technologies
- Innovative Energy Harvesting Technologies
- Vehicle emissions and performance
- Magnetic and transport properties of perovskites and related materials
- High voltage insulation and dielectric phenomena
- Quantum Mechanics and Applications
- Magnetic Properties of Alloys
- Geological and Geochemical Analysis
Wuhan University of Technology
1996-2024
KU Leuven
2024
Xiamen University
2024
Thermoelectric technology has revealed the potential for automotive exhaust-based thermoelectric generator (TEG), which contributes to improvement of fuel economy engine-powered vehicle. As a major factor, thermal capacity and heat transfer exchanger affect performance TEG effectively. With energy exhaust gas harvested by modules, temperature gradient appears on surface, so as interior flow distribution exchanger. In order achieve uniform higher interface temperature, characteristics...
The power generation of an exhaust TEG (thermoelectric generator) depends on heat energy and thermoelectric conversion efficiency. However, there are compatibility problems among TEG, CC (catalytic converter) muf (muffler). present work tried to vary the installation position propose three different cases. Case 1: is located at end system; case 2: between muf; 3: upstream muf. Simulation experiment were developed compare thermal uniformity pressure drop characteristics over operating From...
In our work, the three-dimensional flow in stacks of biaxial E-glass fiber non-crimp fabrics (NCF) and unidirectional carbon layers was monitored by etched optical sensors embedded inside fabric stack. The influence embedding with a diameter 200 µm on experimentally illustrated discussed. out-of-plane permeability two materials estimated radial infusion model using in-plane values as prior knowledge. assumed radius semi-ellipsoidal derived showed good agreement results obtained best fit...
Monitoring of real-time flow and defects in the vacuum-assisted resin infusion (VARI) process can provide important guidelines for full impregnation dry reinforcement. A weak fiber Bragg grating array was employed to obtain quasi-distributed monitoring results real-time. Sensitivity testing different kinds coated optical sensors (OFs) carried out first, polyacrylate-coated OF showed a greater wavelength-shift response than polyimide-coated one. Then, two- three-dimensional tests were out....
Abstract Using the dynamic compression technique, sound velocities of Fe‐11.8 wt % S were measured up to 211.4 (4.5) GPa and 6,150 K. Discontinuities both in shock velocity indicate that completely melts at a pressure 111.3 (2.3) GPa. By energy conservation law, calculated liquidus temperature is about 2,500 (300) Extrapolated inner‐core boundary based on Lindeman 4,300 We developed thermodynamic model fit experimental data, which allows calculation densities liquid Fe‐S under core...
The compaction of a fabric reinforcement in Universal Testing Machine (UTM) allows to determine the achievable fiber volume fraction across wide range pressures, valuable information for composite manufacturing. As seen first international compressibility benchmark, inaccuracies stack thickness measurement, approach compliance correction and non-parallelism between plates resulted highly inaccurate compression curves. In this paper, different variability sources affecting indirect methods,...
We show the special dynamic characteristic of Gaussian quantum discord, exhibited by two-mode symmetric squeezed thermal states (STS) in continuous-variable (CV) systems with a common non-Markovian environment, is denitely dierent from Markov processes.We demonstrate that discord can be created whenever information ow environment back to system.We also rate decrease for related coupling constant.We discover initial value determined average number photons system.
This paper investigated rheological properties of diallyl orthophthalate/poly(vinyl chloride) (DAOP/PVC) blends and interfacial DAOP/PVC composites reinforced by DAOP-modified glass fibres. Various were prepared with dicumyl peroxide, the low-viscosity cross-linkable DAOP was used as a reactive plasticiser to improve processing mechanical properties. On this basis, rheology, thermal property morphology studied rheometer, differential scanning calorimeter, dynamic analysis electron...
Abstract ChemInform is a weekly Abstracting Service, delivering concise information at glance that was extracted from about 100 leading journals. To access of an article which published elsewhere, please select “Full Text” option. The original trackable via the “References”