Kui Wang

ORCID: 0000-0001-5056-9762
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • Graphene research and applications
  • Adsorption and biosorption for pollutant removal
  • Fiber-reinforced polymer composites
  • Nanopore and Nanochannel Transport Studies
  • Conducting polymers and applications
  • Corrosion Behavior and Inhibition
  • Advanced Sensor and Energy Harvesting Materials
  • Plasma Applications and Diagnostics
  • Recycling and Waste Management Techniques
  • Electrodeposition and Electroless Coatings
  • Plasma Diagnostics and Applications
  • Pickering emulsions and particle stabilization
  • Catalytic Processes in Materials Science
  • Graphene and Nanomaterials Applications
  • Membrane Separation and Gas Transport
  • Advanced materials and composites
  • Extraction and Separation Processes
  • Electrohydrodynamics and Fluid Dynamics
  • Advanced ceramic materials synthesis
  • Advancements in Battery Materials
  • Aluminum Alloys Composites Properties
  • Electrostatics and Colloid Interactions
  • Polymer Surface Interaction Studies
  • Concrete Corrosion and Durability
  • Polymer Nanocomposite Synthesis and Irradiation

Shaanxi University of Science and Technology
2024

Ningbo Institute of Industrial Technology
2017-2023

Guiyang University
2022

Chinese Academy of Sciences
2018-2019

Henan Normal University
2015

Ministry of Education
2015

Sun Yat-sen University
2014

In order to hold the excellent corrosion resistance of zinc-rich epoxy coatings with reduced zinc content, five types graphene modified (G-ZRCs) were prepared. The effect content on protection behaviors G-ZRCs was investigated using electrochemical impedance spectroscopy (EIS). Open circuit potential (OCP) also utilized deepen understanding anticorrosion mechanism as-prepared composite coatings. results confirmed that addition 0.3 wt % could make coating 40 (G-40ZRC) and 55 (G-55ZRC) provide...

10.1021/acsanm.8b01821 article EN ACS Applied Nano Materials 2018-12-31

This paper investigated the bacterial inactivation/sterilization effects of a gas-liquid gliding arc discharge reactor, which created plasma at atmospheric pressure and ambient temperature. Bacteria Escherichia coli were subjected to treatment survivability was examined. With bacteria suspension circulated defined flow rate, E. cells almost killed in <;3 min. The inactivation efficiency with circulation much higher than that no circulation, it could even reach reduction 7 logarithm units...

10.1109/tps.2014.2341673 article EN IEEE Transactions on Plasma Science 2014-08-07

ABSTRACT In this work, methods for reactive coating with graphene (method A and B) are performed to demonstrate feasible ways functionalize ultra‐high‐molecular weight polyethylene (UHMWPE) fibers. First, fiber surfaces were polarized by polydopamine (PDA) amino hydroxyl groups. method A, a benchmark method, fibers dipped into oxide (GO) suspensions multiple (e.g., eight) cycles absorb GO, which was then reduced on surface. B, dipping operations repeated the same number of cycles, but...

10.1002/app.48946 article EN Journal of Applied Polymer Science 2020-01-09

Abstract The present study investigates the influences of SiC incorporation on microstructure and corrosion behavior B 4 C– n composites in molten FLiNaK salt at 800°C. characteristics mechanisms were thoroughly characterized extensively discussed. exhibited a more refined grain size lowered apparent porosity as content increased. Additionally, concentration high‐angle boundaries (HAGBs) increased 10 wt.% improved resistance against salt. However, excessive (≥20 wt.%) did not improve...

10.1111/ijac.14722 article EN International Journal of Applied Ceramic Technology 2024-02-27

Abstract In this study, different degrees of ethylene‐confined polymerization (non‐confined, slightly confined, and highly confined) are presented in porous polymer microspheres (PPMs) with an interconnected tri‐modal pore structure. First, three catalysts, Cp 2 ZrCl , TiCl 4 attached to the interface PPMs form a nano‐confined space for ethylene polymerization. Then types polyethylene obtained through Results SEM, BET, FTIR, XPS confirm existence structure after catalyst loading, which can...

10.1002/macp.201800362 article EN Macromolecular Chemistry and Physics 2018-11-02

Abstract In this work, a comparative study of thermally reduced graphite oxide (rGO) materials prepared by thermal exfoliation and reduction (GO) at the temperature 300 °C 600 under different atmospheres (air, N 2 , Ar, vacuum H ) was investigated through kinds characterizations. The evaluation chemical structure quality rGOs these various is high importance attempted side‐by‐side for first time in paper. order C/O ratio obtained that HH‐rGO&gt;HV‐rGO&gt;HAr‐rGO≈HN‐rGO&gt;HA‐rGO, whereas...

10.1002/slct.201803473 article EN ChemistrySelect 2019-02-05
Coming Soon ...