A5107701140- Extraction and Separation Processes
- Advancements in Battery Materials
- Metal and Thin Film Mechanics
- Advanced ceramic materials synthesis
- Advanced Surface Polishing Techniques
- Advanced Battery Technologies Research
- Surface Modification and Superhydrophobicity
- Supercapacitor Materials and Fabrication
- Bone Tissue Engineering Materials
- Catalysis and Oxidation Reactions
- Chalcogenide Semiconductor Thin Films
- Adhesion, Friction, and Surface Interactions
- Advanced materials and composites
- Advanced Photocatalysis Techniques
- Fluid Dynamics and Thin Films
- Additive Manufacturing and 3D Printing Technologies
- Laser Material Processing Techniques
- Silicon and Solar Cell Technologies
- Chemical Looping and Thermochemical Processes
- Catalytic Processes in Materials Science
- Quantum Dots Synthesis And Properties
Clemson University
2020-2024
Kunming University of Science and Technology
2019-2021
Sichuan Research Center of New Materials
2019
Shanghai Liangyou (China)
2004
The present study proposed a novel and efficient ultrasonic-Cu catalyzed chemical leaching (U-CuCCL) method to purify large-sized industrial silicon powders. Different from the traditional ultrasonic-HF (U-HF) method, U-CuCCL combined rapid thermal processing (U-CuCCL + RTP) were performed investigate efficiency of removing main impurities Fe, Al, Ca, Ti, Ni, V, Cu, Mn. evolution typical precipitates phases on surface before after observed analyzed by electron probe micro analyzer. results...
Films formed by dip coating brass wires with dilute and semi-dilute solutions of polyvinyl butyral in benzyl alcohol were studied their liquid solid states. While behaved as Maxwell viscoelastic fluids, the thickness films followed Landau-Levich-Derjaguin prediction for Newtonian fluids. At a very slow rate coating, film was difficult to evaluate. Therefore, dynamic contact angle detail. We discovered that polymer additives preserve advancing at its static value while receding follows...
In this paper, we demonstrate a method of measuring the flexural elastic modulus ceramics at an intermediate (~millimeter) scale, high temperatures. We used picosecond laser to precisely cut micro-beams from location interest in bulk ceramic. They had cross-section approximately 100 μm × 300 μm, and length ~1 cm. were then tested thermal-mechanical analyzer room temperature, 500°C, 800°C, 1100°C using four-point testing method. compared moduli high-purity Al2O3 AlN measured by our with...
In this paper, we demonstrate a method of measuring the flexural elastic modulus ceramics at an intermediate (~millimeter) scale high temperatures. We used picosecond laser to precisely cut microbeams from location interest in bulk ceramic. They had cross-section approximately 100 μm × 300 and length ~1 cm. were then tested thermal mechanical analyzer room temperature, 500 °C, 800 1100 °C using four-point testing method. compared moduli high-purity Al