- Dyeing and Modifying Textile Fibers
- Microbial Metabolism and Applications
- melanin and skin pigmentation
- Biological Stains and Phytochemicals
- Pigment Synthesis and Properties
- Recycled Aggregate Concrete Performance
- Innovations in Concrete and Construction Materials
- Histiocytic Disorders and Treatments
- Metal Alloys Wear and Properties
- Herpesvirus Infections and Treatments
- Cultural Heritage Materials Analysis
- Astronomical Observations and Instrumentation
- Congenital limb and hand anomalies
- Metallurgy and Material Forming
- Optical Systems and Laser Technology
- Metallurgy and Material Science
- Virology and Viral Diseases
- Advanced ceramic materials synthesis
- Innovative concrete reinforcement materials
- Advanced Measurement and Detection Methods
- Bone Tumor Diagnosis and Treatments
- Powder Metallurgy Techniques and Materials
- Advanced materials and composites
- Food Quality and Safety Studies
Qiqihar University
2022-2024
Tangshan College
2023
Harbin Institute of Technology
2022
Harbin Medical University
2015-2016
Institute of Endemic Disease Control in Shandong Province
2015
Tsinghua University
1994
The application of plant dyes in the textile industry has been very limited due to their sources, incomplete color space, and narrow gamut, etc. Therefore, studies properties gamut natural corresponding dyeing processes are essential for completing space application. In this study, water extract from bark Phellodendron amurense (P. amurense) was used as a dye. Dyeing properties, evaluation dyed cotton fabrics were studied, optimal conditions obtained. results showed that process...
Natural dyes play an important role in sustainable dyeing processes. However, natural yellow with good performance are rare. Traditional have issues, such as a narrow color range and poor light fastness. In this paper, new dye was extracted from low-cost herb Geranium caespitosum L. (G. caespitosum). addition, the composition analyzed using UV-visible spectroscopy. The process of G. on wool fabrics optimized single-factor experiments. Standard fastness tests were conducted to evaluate...
Stress‐induced martensitic transformation plastic zones in ceria‐stabilized tetragonal zirconia polycrystalline ceramics (Ce‐TZP), under loading conditions of uniaxial tension, compression, and three‐point bending, are studied by experiments. The transformed monoclinic phase volume fraction distribution the corresponding strain surface morphology (surface uplift) measured means moire interferometry, Raman microprobe spectroscopy, measurement system. experimental results from above three...
Big recycled aggregate self compacting concrete is a new type of concrete, which has the advantages low hydration heat and green environmental protection, but its bending behavior can be affected by different replacement rate. Therefor, in this paper, research status big Recycled was systematically introduced, effect rate on failure mode, crack distribution strength beam were studied through test 4 beams. The results show that: rate; modes beams are same as those ordinary concrete; plane...
Objective By X-ray measurement of metacarpal and phalange bones in the right hand 200 adults Kaschin-Beck disease (KBD) regions, Qinghai Province, to understand basic conditions adult patients with KBD, provide anatomic data information for clinic diagnosis application surgery. Methods In 2013, KBD areas were taken examination Xinghai, Guide Tongde endemic Province. According The Diagnostic Standard Disease, 78 diagnosed by X-ray, others healthy control group, then measured electronic...
In this study, natural dyes were extracted from acer ginnala dried leaves and applied on wool fabric. The preferred mordant post-mordant dyeing performance fabric with Acer confirmed by color strength (K/S). influence of different factors characteristic value was revealed qualitative analysis carried out the samples dyed concentration solution times. experimental results showed that application largest. Moreover, characteristics values influenced lightness L* (14.89-59.57), purity C*...
Objective To analyze the radiographic characteristics of right hand X-ray film adult patients with Kaschin-Beck disease (KBD) in Qinghai Province, to understand most affected locations KBD. Methods According criteria KBD diagnose (WS/T 207-2010), 111 cases were taken films hands. Joint space narrow, joint deformity, subchondral sclerosis, osteophyte, coarse and irregularity joint, marginal retraction sign capsule changes chosen as descriptive indexes, these indexes analyzed SPSS...
Line structured light sensors are widely used in 3D measurement. To obtain completed results of complex profiles, the measurement system usually needs multiple sensors. Due to misalignment laser plane, accuracy overlapped profile is hard be guaranteed. Therefore, a plane pose adjustment method based on target proposed. Firstly, obtained by fitting test points whose coordinate values computed use invariance cross-ratio principle. After obtaining coefficient corresponding normal vector and can...