A5038934795- Aluminum Alloys Composites Properties
- Advanced materials and composites
- Additive Manufacturing Materials and Processes
- High Entropy Alloys Studies
- Magnesium Alloys: Properties and Applications
- Advanced ceramic materials synthesis
- Laser Material Processing Techniques
- Aluminum Alloy Microstructure Properties
- Plasmonic and Surface Plasmon Research
- High-Temperature Coating Behaviors
- Optical Coatings and Gratings
- Advanced Surface Polishing Techniques
- Additive Manufacturing and 3D Printing Technologies
- Welding Techniques and Residual Stresses
- Electronic Packaging and Soldering Technologies
- Laser-induced spectroscopy and plasma
- Advanced Welding Techniques Analysis
- Microstructure and mechanical properties
- Ion-surface interactions and analysis
- Metal and Thin Film Mechanics
- Integrated Circuits and Semiconductor Failure Analysis
- Near-Field Optical Microscopy
- Orthopaedic implants and arthroplasty
- Transportation Planning and Optimization
- Surface Roughness and Optical Measurements
Nanyang Technological University
2016-2025
Central South University
2022-2025
Xiangnan University
2025
Tongji University
2025
Research Institute of Highway
2011-2024
Bundesministerium für Klimaschutz, Umwelt, Energie, Mobilität, Innovation und Technologie
2014-2024
Ministry of Transport
2010-2024
Jilin Agricultural University
2024
Yibin University
2024
Jiangxi University of Science and Technology
2024
In this study, the flow characteristics and behaviors of virgin recycled Inconel powder for powder-bed additive manufacturing (AM) were studied using different characterization techniques. The results revealed that particle size distribution (PSD) selective laser melting (SLM) process is typically in range from 15 μm to 63 μm. rate around 28 s·(50 g)−1. addition, packing density was found be 60%. rheological test indicate has reasonably good flowability compared with powder. inter-relation...
Wire arc additive manufacturing (WAAM) is suitable to fabricate large components because of its high deposition rate. In this study, a metal-cored low-alloy high-strength welding filler metal was used as feedstock. Single wall structures were prepared using the WAAM process with different interpass temperatures (150 °C, 350 and 600 °C). No obvious microstructure change observed when alloy deposited 150 °C °C. Electron backscattered diffraction analysis shows that no significant texture...
Phase-unwrapping algorithms, an active and interesting subject in recent years, are important a great number of measurement applications. Active research is being undertaken to develop reliable high-speed procedures. The current process uses gray-scale mask the flood-fill concept from image processing for phase unwrapping. algorithm unwraps area with higher reliability one lower reliability. In addition robustness, speed proposed much faster than conventional routines. experimental results...
In this study, tensile tests of 63Sn/37Pb solder were carried out at various strain rates from 10−5 s−1 to 10−1 over a wide temperature range −40°C 125°C study the effect rate and testing on mechanical properties in systematic manner. Based these experimental data, set empirical formulae was derived by statistical method describe quantitative manner explain variation published other reports. It is concluded that can be used characterize temperatures rates.
A silver film-based superlens, a plasmonic microzone plate, is put forth for the purpose of superfocusing at visible regime. The numerical analysis results reveal that it has unique focusing characteristics longer focal length and depth focus with resolving power beyond diffraction limit in comparison to conventional zone plates. Working near field, increases working distance l field from l<λ∕10 l≈λ∼5λ. This feature makes promising superlens be used as probe optical systems high...