Ke Luo

ORCID: 0000-0002-3069-8636
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • Remote Sensing in Agriculture
  • Remote Sensing and LiDAR Applications
  • Plant Water Relations and Carbon Dynamics
  • Electromagnetic Launch and Propulsion Technology
  • Superconducting Materials and Applications
  • Atmospheric and Environmental Gas Dynamics
  • Magnetic Properties of Alloys
  • Land Use and Ecosystem Services
  • Dental materials and restorations
  • Rheology and Fluid Dynamics Studies
  • Aerodynamics and Acoustics in Jet Flows
  • Sports Dynamics and Biomechanics
  • Acoustic Wave Phenomena Research
  • Soil Carbon and Nitrogen Dynamics
  • Covalent Organic Framework Applications
  • Dental Implant Techniques and Outcomes
  • Blood properties and coagulation
  • Gold and Silver Nanoparticles Synthesis and Applications
  • Recycling and Waste Management Techniques
  • Power Systems and Technologies
  • Vehicle Noise and Vibration Control
  • Ecosystem dynamics and resilience
  • Extraction and Separation Processes
  • High voltage insulation and dielectric phenomena
  • Mechanical Failure Analysis and Simulation

Catalytic Materials (United States)
2025

Hunan University
2024-2025

Huazhong University of Science and Technology
2025

Wuhan National Laboratory for Optoelectronics
2025

University of Kentucky
2024

State Key Laboratory of Chemobiosensing and Chemometrics
2024

Chengdu University of Technology
2011-2024

Southern Medical University
2022-2024

Shaanxi University of Chinese Medicine
2024

Delft University of Technology
2023

Abstract Objectives This study evaluated the accuracy of dental implant placement using robotic computer‐assisted surgery (r‐CAIS) technology in fully edentulous patients. Materials and Methods Fully terminal dentition patients were enrolled for r‐CAIS technology. Based on cone‐beam computed tomography (CBCT) examination, a customized positioning marker preoperative surgical plan created before surgery. During surgery, osteotomy automatically performed an autonomous system under surgeon's...

10.1111/clr.14188 article EN cc-by-nc Clinical Oral Implants Research 2023-10-19

Open AccessCCS ChemistryRESEARCH ARTICLES11 Apr 2024CO2 Capture in Liquid Phase and Room–Temperature Release Concentration Using Mechanical Power Aimin Li, Yuanchu Liu, Ke Luo Qing He Li , Liu https://doi.org/10.31635/ccschem.024.202404292 SectionsSupplemental MaterialAboutPDF ToolsAdd to favoritesDownload CitationsTrack Citations ShareFacebookTwitterLinked InEmail Development of advanced materials with high CO2 capture capacity and, inter alia, superior regenerability low energy consumption...

10.31635/ccschem.024.202404292 article EN cc-by-nc CCS Chemistry 2024-04-11

Gold nanoclusters (AuNCs) are highly promising for applications in photothermal conversion due to their exceptional surface area and optical properties. However, high energy often leads aggregation, compromising stability performance. To address this, we developed a ferritin-inspired covalent organic cage with near-enclosed cavity physically stabilize AuNCs. This superphane coordinates Au3+ ions, forming stable uniform AuNCs upon reduction. The encapsulated exhibit broad absorption (250-2500...

10.1002/anie.202500058 article EN Angewandte Chemie International Edition 2025-02-26

Gold nanoclusters (AuNCs) are highly promising for applications in photothermal conversion due to their exceptional surface area and optical properties. However, high energy often leads aggregation, compromising stability performance. To address this, we developed a ferritin‐inspired covalent organic cage with near‐enclosed cavity physically stabilize AuNCs. This superphane coordinates Au3+ ions, forming stable uniform AuNCs upon reduction. The encapsulated exhibit broad absorption (250–2500...

10.1002/ange.202500058 article EN Angewandte Chemie 2025-02-26

The paper presents the effect of exhaust gas and inlet air temperature on thermal efficiency for boiler system. Based numerical model, performance indexes system are calculated at different conditions using EES (Engineering Equation Software). results show that when exhausted or increases 10-15°C, heat loss decreases 0.8%-1% 0.8%-1%; crucial factors can affect fuel volatile ratio; seven optimized schemes designed a case A new methodology is provided evaluating

10.1016/j.egypro.2017.03.629 article EN Energy Procedia 2017-05-01

Abstract Background Soil organic carbon (SOC) is a critical component of the global cycle, and an accurate estimate regional SOC stock (SOCS) would significantly improve our understanding sequestration cycles. Zoige Plateau, locating in northeastern Qinghai-Tibet has largest alpine marsh wetland worldwide exhibits high sensitivity to climate fluctuations. Despite increasing use optical remote sensing predicting SOCS, obvious limitations Plateau due highly cloudy weather, knowledge on spatial...

10.1186/s13717-024-00515-7 article EN cc-by Ecological Processes 2024-05-01

The separation properties of the aluminium–plastic laminates in postconsumer Tetra Pak structure were studied this present work. organic solvent blend benzene–ethyl alcohol–water was used as reagent. Then triangle coordinate figure analysis taken to optimize volume proportion various components separating agent and process. And temperature determined by time, efficiency, total mass loss products. results show that cost-efficient separations perform best with low usage solvents at certain...

10.1177/0734242x14525823 article EN Waste Management & Research The Journal for a Sustainable Circular Economy 2014-03-12

Abstract BACKGROUND In order to understand Al– PE composite delamination during the separation process, interfacial and characterization of composites were analyzed. The aim was enrich present theoretical analysis provideg new ideas for recycling reuse post‐consumer Tetra Paks. RESULTS delaminated into three layers, but times two plastic layers different. After separation, some plastics in solvents analyzed by FTIR . Bright spots unregular particles with scattered distribution on surfaces...

10.1002/jctb.4573 article EN Journal of Chemical Technology & Biotechnology 2014-10-15

10.1016/j.jmbbm.2018.09.017 article EN publisher-specific-oa Journal of the mechanical behavior of biomedical materials/Journal of mechanical behavior of biomedical materials 2018-09-15

Transient rheological properties of poly(ethylene glycol) diacrylate (PEGDA) hydrogels under Couette flow conditions are determined via molecular dynamics simulations and validated by high strain rate shear experiments. Specifically, the influence polymer concentration on transient-state shear-thickening behavior is studied for 20, 25, 50, 70 wt % PEGDA hydrogels. The transient response characterized introduction dimensionless variables application a self-similar solution to power-law fluid...

10.1021/acs.macromol.9b00820 article EN Macromolecules 2019-07-26

The high strain rate behavior of nonideal poly(ethylene glycol) diacrylate hydrogels under uniaxial tension and transient-state shear deformations is investigated using molecular dynamics (MD) simulations. This work specifically focuses on the influence first-order loop defects, including their effect topological evolutions. Two approaches are proposed to systematically introduce loops, allowing separate controllable investigations effective cross-link functionality density. MD simulations...

10.1021/acs.jpcb.9b11378 article EN The Journal of Physical Chemistry B 2020-02-10

Molecular dynamics simulations are used to study binary blends of an AB-type diblock and AB2-type miktoarm triblock amphiphiles (also known as high-χ block oligomers) consisting sugar-based (A) hydrocarbon (B) blocks. In their pure form, the AB AB2 self-assemble into ordered lamellar (LAM) cylindrical (CYL) structures, respectively. At intermediate compositions, however, AB2-rich blend (0.2 ≤ xAB 0.4) forms a double gyroid (DG) network, whereas perforated lamellae (PL) observed in AB-rich...

10.1021/jacsau.2c00101 article EN cc-by-nc-nd JACS Au 2022-05-31

10.1016/j.jmbbm.2021.104423 article EN Journal of the mechanical behavior of biomedical materials/Journal of mechanical behavior of biomedical materials 2021-02-26
Coming Soon ...